FM AntennaAM AntennaCD PLAYER
L R Optical Coax
Figure 4 � Audio Connections
REC/INDashed lines (����) indicate coaxial and optical
digital audio connections. Choose either type
(but not both) for each digital audio source.
PLAY/OUT
AUDIO RECORDER
Step 4. Connect AM and FM antennas (Fig. 4) (see page 16).The Component Video 1 inputs default to the DVD player, but may besatellite-type speakers and a subwoofer. Otherwise, press the Speaker
Step 5. Connect source components, as shown in Figures 4 and 5, and thereassigned. Connect the component, composite and S-Video Monitorbutton and then the Set and arrow buttons to select the correct
Device Connection Options chart on the back of this guide (seeoutputs to your Video Monitor (TV). Switch your TV setOs input tospeaker choices for your system (see pages 23�25).
pages 16�17).match the type of video used for the currently selected source.Step 9. Set the Output Levels with EzSet: Set the Volume to �15dB.
AUDIO connections: Right channel (red) on source to right (red) Step 6. Plug all components into AC power outlets. The outlets on the backSit in the listening position and hold the remote in front of you at
on AVR, and left channel (white) on source to left (white) on AVR.of the AVR 630 should be used only for low-current products, suchshoulder level, pointing it at the AVR. Press the EzSet button on the
DIGITAL AUDIO connections, if available: Choose either coaxialas CD or DVD players, and the total should not exceed 100 watts.remote, and then the Set button when it lights red. Following the
(orange) to coaxial (orange) OR optical to optical for each device.Basic Receiver Configurationinstructions in the remoteOs LCD display, press the button on the
The Coaxial 1 input defaults to the DVD player; however, it may beStep 7. Select digital inputs: If your DVD is connected to Coaxial 1, noremote until the display shows the number of speakers in your system
reassigned. Assign the other digital inputs and outputs as appropriateadjustment is needed. For any other digital-device connections, useand then press the Set button again. Hold the remote steady until the
for your equipment (see Step 7).the front-panel Digital Select button and the arrow buttons to selectLCD display flashes a COMPLETE message (see page 26).
VIDEO connections: Choose component (Y/Pb/Pr � green/blue/an optical or coaxial digital input (see pages 21 and 32).Step 10. Your system is configured � sit back and enjoy!
red), composite (yellow) or S-Video (4-pin) for each video source.Step 8. Configure speakers: No action is needed if you have five Osmall�
SPEAKER AND AUDIO CONNECTIONS |
ACEC
HARMAN KARDON
