INSTALLATION INSTRUCTIONS
WATER SUPPLYWATER STOP (depending on model)
Water supply: only cold water. The inlet hose and the plastic enclosure at
Tap: 3/4¨ threaded hose connector.the water connection contain electrical
components.
Water pressure (mains pressure):
2 Do not cut the flexible hose and do not
10-100 N/cm (1-10 bar).
immerse the plastic enclosure in water.
For Great Britain & Ireland only: If the hose is damaged, unplug the appliance
Water inlet: hot and cold fill.from the mains immediately.
The warm water inlet temperature must not If the hose is not long enough, replace it with
exceed 60°C.a 3 m long ?Water Stop? hose (available from
After-Sales Service or a specialist dealer).
INLET HOSE(S)This must be done only by a qualified
electrician.
Note: If the inlet hose is already fitted to the rear
panel on the appliance, ignore points 1 and 4.
1. Remove the inlet hose from the drum.
2. Fit the mesh filter supplied in the thread
between the straight end of the inlet hose(s)
and the tap(s).
3. Carefully screw the straight end of the inlet
hose(s) to the tap(s) by hand.
4. Screw the curved end of the hose to the
appliance taking care that the hose is not
kinked.
5. Turn the tap(s) on fully and check that the
joints at the washing machine and the tap(s)
are watertight.
If the hose is not long enough, replace it with
a suitable length of pressure-resistant hose
(approved under EN 500 65 to withstand a
minimum of 10 bar).
Check the hose regularly for brittleness and
cracks and replace if necessary.
The washing machine may be connected
without a non-return valve.
Observe any special local regulations
regarding connection to the water supply.
54 |
ACEC
WHIRLPOOL
