3gb05030.fm5 Page 32 Monday, September 17, 2001 3:33 PM
a. Water inlet fault (no or insufficient water c. Electrical module fault
supply)The display shows ?F4? to ?F15?.
The ?Water tap? indicator is on or the display ? Switch off the appliance. Select a programme
alternately shows ?FH?. Switch off the appliance and press the ?Start/Pause? button once again.
by turning the programme selector to the ?? The programme will continue.
position and unplug it.? If the fault re-occurs, contact After Sales Service
Check wheter:(See ?After-Sales Service?).
? the water tap is completely open, and the water
supply pressure is sufficient;d.Water Stop fault (if available)
? the water inlet hose is kinked;
An audible tone sounds. The light of the Water
? the mesh filters are blocked (see ?Care and Stop indication is on.
Maintenance? / ?Water Hose Mesh Filters?);The display shows ?FA? and the pump is running.
? the water inlet hose is frozen.Switch off the appliance by turning the
Connect the appliance to the electrical supply.programme selector to the ?? position, unplug
the appliance and make sure that the water tap is
Reselect the desired programme and press the closed.
?Start/Pause? button again to continue with the
programme (do not add detergent for this The ?Water Stop? may have been triggered
programme)by:
b.Draining out fault1.too much foam.
The display alternately shows ?FP?. Switch off the 2.a leak in the inlet hose or in the appliance.
appliance by turning the programme selector to Tilt the appliance forwards carefully to allow the
the ?? position and unplug it.collected water to flow out.
Check whether:Then:
? the drain hose is kinked (see ?Installation 1.connect the appliance to the electrical supply,
Instructions?);2.open water supply to machine (if ?Start/Pause?
? the pump / filter are blocked (see ?Removing the button is not pressed, but machine begins to fill,
Filter / Draining Residual Water?).close water supply and call After-Sales Service),
IMPORTANT: before draining, allow the wash 3.reselect the desired programme and press the
water to cool down.?Start/Pause? button (there is no need to add
? the drain hose is frozen.additional detergent). The programme will
Connect the appliance to the electrical supply.continue.
If the faults occurs again, call After-Sales Service with
Reselect the desired programme and press the details about the fault (see ?After-Sales Service?).
?Start/Pause? button again to continue with the
programme (do not add detergent for this
programme).
If the fault re-occurs, contact After-Sales Service
(see ?After-Sales Service?).
32 |
ACEC
WHIRLPOOL
