3GB150091.fm Page 2 Tuesday, July 29, 2003 9:50 AM
Press the button to set another spin speed.
CONSUMPTION DATACHANGE THE PROGRAMME, TEMPERATURE,
If the spin speed ?0? is selected, the final spinning is
OPTIONS AFTER PROGRAMME START
cancelled but intermediate spin peaks remain during
Temperature Selector LoadWaterEnergyApproximate programme
rinse. The water is drained out only.
Programmeduration*1. Press the ?Start/Pause? button to interrupt the
(°C)(kg)(l)(kWh)(hours : minutes)START DELAYprogramme. The light flashes.
White Cotton958.080**2.602:202. Select the new programme (with temperature),
The ?Start Delay? allows to run the machine at the any options and another spin speed if you want.
Coloured cotton608.0721.452:15
consumer?s convenience, for example at night when ?Start/Pause?
3.Press the button again. The new
Coloured cotton603.5451.101:15electricity is cheaper.programme continues at the same position where
Coloured cotton601.0250.701:00 Select programme, temperature and options.the previous programme was interrupted. Do not
Press the ?Start Delay? button to select the delay add detergent for this programme.
Coloured cotton408.0720.752:05
time by 1 to 23 hours;
Synthetics403.5550.551:15CANCEL A PROGRAMME BEFORE THE END
Press the ?Start/Pause? button.
Daily Load 40°403.5450.551:00 The time delay indication disappears when the
Press the ?Reset? button. Any existing water is
Rapid plus303.5350.350:30programme starts and it is replaced by the
drained out before the door can be opened.
remaining time.
Delicates302.5650.450:50
The number of hours preselected can later be CHILD LOCK
Wool402.0600.500:35
reduced pressing again the ?Start Delay? button.
Handwash302.0600.300:31To cancel the ?Start Delay?.Detailed information can be found in the instructions
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized Turn the programme selector to the ?? position.for use.
conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in The controls can be locked to avoid interference by
Reselect the desired programme and options and
the table in relation to the water supply pressure and temperature, the load and the type of wash.children.
press the ?Start/Pause? button.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the 1. If the machine is off:
household conditions applicable at that time.Turn the programme selector knob from the ?0?
PROGRAMME START
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the position to any programme. Do not press the
water out.?Start/Pause?
Turn on the tap and press the button. ?Start/Pause? button. Press the ?Child Lock?
?Prewash? button
The pilot lamp of the ?Start/Pause? button lights up.
ADD DETERGENT, CLOSE THE DOOR AND SELECT THE button for 5 seconds. The ?Child Lock? indicator
Only for heavily soiled laundry (e.g. sand, granular The indicator lamps shows the sequence reached in lights up. Turn the programme selector knob to
PROGRAMMEdirt). The cycle time increases approx. 15 minutes.
the programme. After starting the programme, the the OFF position ?? again.
?Intensive Rinse? button
Add the detergent as described in the programme table sequence indication runs from top to bottom through
More water and a longer time in rinse cycle is added.2. While a programme is running:
or in the chapter ?Detergent and Additives? of the Prewash, Wash, Rinse, Spin.
This option is particularly suitable for areas with very Press the ?Child Lock? button for 5 seconds. The
instructions for use.When a sequence of the programme is finished the
soft water, for baby clothes and to help people with child lock indicator will light up.
1. Turn the programme selector knob to the desired corresponding lamp goes out.
allergies.
programme.Now, in spite of the programme selector knob being
2. The remaining time display shows the duration of ?Rinse Hold? buttonDOOR LOCKturned, no programme can be started or altered.
the chosen programme (in hours and minutes) and The laundry remains in the last rinse water without However, a running programme can be stopped at any
After each programme start the door is locked and
the pilot lamp of the ?Start/Pause? button lights being spun: this prevents creasing and colours from time (e.g. in an emergency), by turning the
approx. 0.5 l of water is rinsed in. The door is
up.changing.programme selector knob to ??. Attempts at
unlocked for a few seconds. The door is then locked
3. The programme sequence and the predefined spin This option is particularly recommended for the until the end of the programme. The door cannot be changing during the running programme are signalled
speed indicators corresponding to the selected programme ?Synthetics? or ?Delicates?.by the lamp flashing. The indicator light for the
opened while the ?Door Locked? indicator is on.
programme light up. This function is particularly useful if you want to actual programme running goes on.
Detailed information can be found in the instructions
The recommended temperature (see the indicator) can postpone spinning to a later time, or if you want to To unlock the controls, the machine must either have
for use.
be altered by pressing the ?+? or ?-? button.drain only.a programme running or be in select mode. Press the
Note: The programme starts to ?Rinse Hold? as soon as PROGRAMME END?Child Lock? button for 5 seconds. The child lock lamp
SELECT ANY DESIRED OPTION
the ?Rinse Hold? indicator light in the programme will go out.
The time remaining is ?0:00? and the ?End?- light
Selecting any option the indication lights up.display lights up.
is on.
When the combination of programme, additional Terminate the ?Rinse Hold? option:
options and temperature is not possible, the Press the ?Rinse Hold? button again; the programme 1. Turn the programme selector knob to the ??
indication lights switch off automatically and a will terminate automatically with the final spin cycle position.
signal sounds.for the present wash programme.2.Turn the tap off and leave the door ajar to allow
the drum to dry out.
?Easy Ironing? button If you do not wish to spin the clothes, turn the
Can be used together with all programmes to reduce programme selector knob to the ?Drain? programme
creasing.and press the ?Start/Pause? button again when
Increases the water quantity and the clothes are flashing.
spun very gently.?Spin Speed? button
Every programme has an automatic predefined
maximum spin speed.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 15091
Black process 45.0° 100.0 LPI |
ACEC
WHIRLPOOL
