3gb05457.fm Page 3 Wednesday, March 5, 2003 2:53 PM
HOT / COLD FILL INSTRUCTION
If you wish to connect If you wish to connect only the cold
hot and cold water fill follow the below
supply (Fig.1):instruction (Fig.2):
1. Fix the red marked inlet hose at the hot 1. You need a Y-piece connector. The
water tap and at the inlet valve with the red Y-piece connector can be ordered via our
filter on the rear side of machine.Service Organization or purchased in a
2. Fix the other inlet hose at the cold water specialized hydraulic component store.
tap and at the inlet valve with the blue 2. Fix the Y-piece connector to the cold fill
filter on the rear side of the machine.tap.
3. Connect the two inlet valves present on
Make sure:the rear part of the machine to the Y-
a) The connections are tightly fixed piece connector using the relative
b) Do not invert their position provider hoses.
(for example: cold fill into hot inlet valve
Make sure:
and viceversa). All connections are tightly fixed.
Fig.1Fig.2
Do not allow children to operate, crawl on, near or inside your
washer.
Note that during wash cycles, the surface temperature of the
porthole door may increase.
Close supervision of children is necessary when the appliance is
used near children.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 05457
Black process 45.0° 100.0 LPI |
ACEC
WHIRLPOOL
