30110300GB.fm Page 12 Tuesday, May 2, 2006 6:31 PM
Fault description table
Digital display
Red indication light is onFault description
(if fitted on your machine)
?Water tap closed??FH??Water supply fault?
?Clean pump??FP??Draining fault?
?Electrical module fault?
from ?F02? to ?F35? or ?FA?
?Waterstop fault?
?Service?or ?Fod?
?Overfoaming?
a.?Water tap closed? indication lights upc. ?Service? indication lights up
The appliance has no or insufficient water supply.The appliance stops during the programme.
For models with remaining time display, ?FH? For models with a remaining time display, a failure
appears on that display. The ?Start/Pause? code between ?F02? and ?F35?, ?FA? or ?Fod?
indicator flashes.appears on that display.
Check whether:If a failure code between ?F02? and ?F35?
the water tap is fully open and there is sufficient appears on the display:
water supply pressure.Select and start the ?Drain? programme or push the
kinks are present in water hose.?Reset? button for at least 3 seconds.
the mesh filters of the water supply are blocked Then select and start the desired programme again.
(see ?Care And Maintenance?/?Mesh Filters For If the fault persists, unplug the appliance and contact
Water Connection?).After-Sales Service (see ?After-Sales Service?).
the water hose is frozen up.If failure code ?FA? appears on the display:
After the problem has been removed, restart the
Switch the appliance off, pull out the mains plug and
programme by pressing ?Start/Pause? again.turn the water tap off. Tilt the appliance forward
If the fault occurs again, contact After-Sales Service carefully to allow the collected water to flow out
(see ?After-Sales Service?).from the bottom of the appliance.
b.?Clean pump? indication lights upThen:
1.connect the appliance to the electrical supply;
Waste water is not pumped out.
2.turn the water tap on (if water immediately flows
The ?Clean pump? indication lights up.
into the appliance again, without the appliance
For models with a remaining time display, ?FP?
being started, there is a failure. Turn off the tap
appears on that display.
and notify After Sales Service);
The washing machine stops in the appropriate 3.select and start the desired programme again.
programme step.
If the failure occurs again, unplug the appliance and
Unplug the appliance.
contact our After Sales Service (see ?After Sales
Check whether:Service?).
kinks are present in the drain hose;
If failure code ?Fod? appears on the display:
the pump or the filter is blocked (see ?Removing
Too much foam interrupted the washing
The Filter?).
programme. Avoid excessive detergent dosing.
IMPORTANT: make sure the water has cooled 1.Select and start the ?Rinse & Spin? programme.
before draining the appliance.
2.Afterwards, select and start the desired
the drain hose is frozen up.
programme again, using less detergent.
Plug in the appliance again.If the fault persists, unplug the appliance and contact
Select and start the ?Drain? programme or push the our After Sales Service.
?Reset? button for at least 3 seconds and restart the
desired programme.
If the fault occurs again, please contact After-Sales
Service (see ?After-Sales Service?).
GB 12 |
ACEC
WHIRLPOOL
