Major operating controls and their functions
o SDI card
1 EVF I/F connector [EVF I/F]2: Model selection <E350/E860>
The EVF I/F cable 9 from the interface (Factory setting: E350)
bracket is connected here.When the AW-E350, AW-E650,
AW-E655 or AW-E750 is used, set
2 SDI output 1, 2 connector this switch at the E350.
[SDI OUT 1, 2]When the AW-E860 is used, set this
SDI signals are output from here.switch at the E860.
3: DATA CLIP <NORMAL/CLIP>
3 Setting switches
(Factory setting: NORMAL)
At the NORMAL setting, signal input
is output at the same level at which it
was input.
At the CLIP setting, signal input at
less than 0% is output at 0%, and
SW NOOFFONsignal input at more than 100% is
1EDHENABLE DISABLEclipped at 100%.
SETTINGE350E860
3 DATA CLIP NORMALCLIP4: NTSC/PAL switching <NTSC/PAL>
NTSC/PALNTSCPAL(Factory setting: NTSC)
Leave this switch at the factory setting.
1: EDH <ENABLE/DISABLE>
(Factory setting: ENABLE)
An EDH flag is added to SDI output at
the ENABLE setting.
- 7 - |
ACEC
PANASONIC
