Connections
:When the pan/tilt head is to be controlled by the AW-RP400 pan/tilt head control panel
for transmitting SDI signals (and the AW-CB400 remote operation panel is used to
control the camera)
Coaxial cable
Camera cableRemote operation
(supplied)panel:
AW-CB400
Cable supplied
with AW-CB400
Pan/tilt control panel:
AW-RP400
Coaxial cable
10BASE-T (equivalent to UTP(BELDEN 8281), max.
category 5) straight cable,666 ft. (200 m)
max. 1640 ft. (500 m)
DC cable
(UL Type SPT-2 2!16 AWG or
UL Type NISPT-2 2!16 AWG,
to be locally purchased)
Color monitor
AC adapter:
AW-PS300A
Y Use the supplied camera cable to connect the unit with the convertible camera
containing the plugged-in SDI card (such as the AW-PB504N).
Y Use a coaxial cable to connect the SDI cardOs SDI OUT connector with the unitOs SDI
IN connector. Adjust the cable to a length at which the pan/tilt head will move
smoothly.
Y Set controller selection switch SW1 to the right side (RP501), and select the
transmission signal selection setting that supports the SDI card.
Y Use a 10BASE-T straight cable (UTP category 5) to connect the unitOs CONTROL IN
IP/RP connector with the controllerOs CONTROL OUT TO PAN/TILT HEAD connector.
Y Use a coaxial cable to connect the unitOs Pr/SDI OUT connector with the color
monitorOs SDI input connector.
Y Use the cable supplied with the remote operation panel to connect the controllerOs
CAMERA CONTROL IN FROM ROP connector with the remote operation panelOs
CONTROL OUT TO CONTROL PANEL connector.
Y Check that the pan/tilt head and camera can be controlled by the controller.
- 36 - |
ACEC
PANASONIC
