DESCRIPTION OF THE DRYER
1. Work-top
2. Condensation water container
3. Contact pin
4. Door (Door opening can be reversed).
See ?Door reversibility? section.
To open the door: pull the handle out.
To close the door: push the door gently until
it closes.
5. Lint filter
6. Child safety-lock
Using a coin or a screwdriver turn the plastic
screw clockwise by 90°.
Slot vertical: the door cannot be closed.
Slot horizontal: the door can be closed.
7. Inside lamp (if available)
Only comes on when the door is open
(the programme has to be selected).
Light off: the programme selector knob is set
to ?0?.
8. Push-button for heat exchanger flap
opening
9. Heat exchanger.
FILTER
Clean the lint filter at the end ofFilte eachr Indicator light
drying cycle.It warns that the filter is dirty and needs to be
cleaned.
1. Pull the filter upwards.
If the laundry is insufficiently dry, check that the
2. Open the filter.
filter is not clogged.
3. Brush lint using a soft brush or your fingertips.
4. Close the filter and push it back well into place.
WATER CONTAINER
Empty the water container at the end of Electronic dryer
each drying cycleSet programme selector knob to ?0?, empty the
water container and restart the programme.
1. Open the flap with the push-push lock by
pressing gently on the right side of the flap
and remove the water container.Time-steered dryer
Empty the water container. Turn the programme
2. Empty the water container.
selector knob to the line on the left of the
3. When it is empty, push container back into
emptying symbol ()(Start button is pressed).
housing until it clicks.
When the pump cycle has finished, turn the
selector knob to the position where it was when
Water container indicator lightthe drying cycle was interrupted.
Indicates that the water container is full and
needs to be emptied. The drying programme is
automatically stopped.
13 |
ACEC
WHIRLPOOL
