2.If you decide to cancel the reload operation at this point, press the
Note nameCC# DD#EFF# GG# AA# B[CANCEL] button.
Display
3.If you wish to reload the factory settings press the [2(WRITE)] but-
ton. The program/value display will indicate � and reloading willO
3.If your guitar is sharp (pitch too high), the Program Up sbegin.witch LED When reloading is completed, the program/value display will
will blink. If your guitar is flat (pitch too low), the Progindicate O ram Down s �, and the AX3G will automatically enter Progwitchram mode.
LED will blink. In either case, more rapid blinking indicates that your
Never turn off the power while reloading.
guitar is farther from the correct pitch.
When in tune, both the Program Up and Down LEDs will light.
Adjusting the tuner calibrationTroubleshooting
When you turn on the power, the built-in tuner is set to a reference pitchIf you suspect a malfunction, please check the following points. If this
of A 440 Hz (concert pitch). You can calibrate this reference pitch in a
does not resolve the problem, please contact a nearby dealer.
range of 438 Hz�445 Hz. You can use the [2 ]/[1 ] buttons to calibrate
this in the range of 438 Hz�445 Hz. When doing so, the prog1.Poram/vwer doaluees not turn on
display will indicate a value of 38�45.Q Have the batteries have run down? When the batteries run low,
When you turn off the power, the calibration adjustment you made willthe display will blink �. WO e recommend that you replace the
be discarded and the AX3G will automatically be set to 440 Hz.batteries as soon as possible. If batteries become unusable, re-
move them immediately. Leaving drained batteries in the unit can
cause malfunctions (such as battery leakage). You should also
remove the batteries if you wonOt be using the AX3G for an ex-
Restoring the factory preset programstended time.
Q Have you have inserted a stereo cable into the INPUT jack?
HereOs how to restore (reload) the AX3GOs programs back to factory pre-
set programs.When operating the AX3G on batteries, the power will not turn
on if you insert a stereo cable. Be sure to use a mono cable.
When you execute this operation, all the programs you created and storedQ Is the AC adaptor connected to the rear panel DC9V jack?
inside the AX3G will be erased, and replaced by the factory programs.Q Is the AC adaptor plugged into an AC outlet?
1.While holding down both the Program Up and Down switches asQ Could the AC adaptor be damaged?
well as the [1 (CANCEL)] button, turn on the power. The prog2.No soundram/
value display will indicate �, and the LEDs in the upper parO Qt ofIs the volume of your guitar turned down?
the Program Up/Down switches will blink. Take your hand off bothQ Is your guitar cable connected correctly?
switches and the button you had been pressing.Q Is your guitar cable broken?
10 |
ACEC
KORG
