HOW TO FINISH UNPACKING
Carefully prise open the sheathing at each end of
Place packed appliance next to the cabinet inthe cable to expose the encased wiring.
which it will be installed.
Remove the appliance packing except for bottomTO REMOVE COVER OF MAINS TERMINAL
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
NOTE: It is imperative that the appliance is left First remove retaining screw with pozidrive
in the base to protect both the appliance and thescrewdriver. See Fig. 5.
floor.
Ensure the owner is given these operating
instructions.
TOOLS REQUIRED
The following tools will be needed and it helps to
assemble them before starting to install your oven:
A terminal screwdriver (3mm wide blade)
A pozidrive screwdriver
PliersFig. 5
Wirestrippers
Knife Prise cover loose using screwdriver in position
Sidecutters(1) then lever off with screwdriver in position (2)
Adhesive tapeat either side. See Fig. 6.
Tape Measure
MAKING THE ELECTRICAL CONNECTIONS
Important: Switch off at mains, miniature circuit
breaker and if appropriate, remove fuse before
commencing any electrical work.
PREPARING CABLE
We recommend you use a new length of cable toFig. 6
ensure your safety.
Ensure you have the correct length of cable
appropriate to the wiring method you are using.
When fitting new cable allow sufficient cable for
removal of the unit at a later date, should it be
necessary.
Score, but do not cut through, around the
sheathing with a knife 100mm (4in) from each
end of the cable and break through to the
encased wires by bending the cable backwards
and forwards to fatigue the sheathing.
Carefully score down from each end of the cable
sheathing along the length of the bare earth wire
(if a cut was made along the length of the live or
neutral wires, it might cut into their sheathing) to
the cuts already made.
10 |
ACEC
OTHERS
