AZ1006-Eng 3/25/05 14:28 Page 6
Power SupplyGeneral operation/Radio
Y Incorrect use of batteries can cause
electrolyte leakage and will corrode the General operation
compartment or cause the batteries to burst:1 To select your sound source adjust the
source selector to : CD, MW, FM or
Y Do not mix battery types: e.g. alkaline withTAPE/OFF.
carbon zinc. Only use batteries of the same
type for the set.2 Adjust the sound with the VOLUME
control.
Y When inserting new batteries, do not try to
mix old batteries with the new ones.3 To switch off the set, adjust the source selec-
Y Remove the batteries if the set is not to betor to TAPE/OFF position and check the
cassette keys are released.
used for a long time.
Using AC MainsRadio reception
1 Check if the power/mains voltage, as shown1 Adjust the source selector to MW or
on the type plate located on the FM.
bottom of the set, corresponds to your
2 Turn TUNING to tune to a station.
local power supply. If it does not, consult yourY For FM, extend and turn the telescopic
dealer or service center
antenna for best reception. Reduce its length
2 If your set is equipped with a voltage selector,if the signal is too strong.
adjust the selector so that it matches with the
Y For MW, the set uses a built-in antenna.
local mains.Direct this antenna for best reception by
3 Connect the power cord to the AC MAINS
turning the whole set.
inlet and the wall socket.The mains lead is3 To switch off the radio, adjust the source
now connected and ready for use.
selector to TAPE/OFF position and check
4 To switch the set off completely, withdraw thethe cassette keys are released.
power cord from the wall socket.
Y Disconnect the mains lead from the wall
socket to protect your set during heavy
thunderstorms.
The type plate is located on the bottom
of the set.
Helpful hints :To avoid unnecessary energy
consumption, always adjust the source
selector to TAPE/OFF after using the set.
Also check that the tape deck keys are
released. |
ACEC
PHILIPS
