XP AZ 1065/01 14-12-2000 11:09 Pagina 13
AZ 1065/00 page 13
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
English
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEM
� POSSIBLE CAUSEindication
Y REMEDY� CD-R(W) is blank or the disc is not finalised
Y Use a finalised CD-R(W)
No sound/power
� CD badly scratched or dirty
� VOLUME not adjusted
Y Replace/ clean CD, see Maintenance
Y Adjust the VOLUME
� Headphones connected
The CD skips tracks
Y Disconnect headphones
� CD is damaged or dirty
� Mains lead not securely connectedY Replace or clean the CD
Y Connect the mains lead properly
� SHUFFLE or PROGRAM is active
� Batteries exhausted/ incorrectly insertedY Quit SHUFFLE/PROGRAM mode(s)
Y Insert (fresh) batteries correctly
Poor cassette sound quality
Severe radio hum or noise� Dust and dirt on the heads, etc.
� Electrical interference: set too close to TV,Y Clean deck parts etc., see Maintenance
VCR or computer
� Use of incompatible cassette types (METAL
Y Increase the distance
or CHROME).
Y Only use NORMAL (IEC I) for recording.
Poor radio reception
� Weak radio signalRecording does not work
Y FM: Direct the FM telescopic aerial for� Cassette tab(s) may be broken
optimum receptionY Apply a piece of adhesive tape over the
Y MW (AM): Direct the aerial by turning themissing tab space.
whole set.
Remote control does not function properly
or indication� Batteries dead/ incorrectly inserted
� No CD insertedY Insert (fresh) batteries correctly
Y Insert a CD� Distance/ angle between the set too large
� CD badly scratched or dirtyY Reduce the distance/ angle
Y Replace/ clean CD, see Maintenance
� Laser lens steamed up,
Y Wait until lens has cleared
The type plate is located on the bottom of the set.
13 |
ACEC
PHILIPS
