AZ1080/00A 03/13/02 10:06 Page 13
Troubleshooting
If a fault occurs,Å¢rst check the points listed below before taking the set for repair.Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints,consult your dealer or
English
service centre.
WARNING:Under no circumstances should you try to repair the set yourself,as this
will invalidate the guarantee.
ProblemSolution
No sound � Adjust the VOLUME
No power� Mains lead not securely connected.
Connect AC mains lead properly
� Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
Display does not function � Electrostatic discharge
properly/ No reaction to Switch off and unplug the set. Reconnect after a few
operation of any of the seconds.
controls
Er indication� No CD inserted, insert a CD
� CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
� CD-R(W) is blank or the disc is not Ţnalized.
Use a Ţnalized CD-R(W)
� Laser lens steamed up.
Wait until lens has cleared/acclimatized
CD playback does not work� CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
The CD skips tracks� CD damaged or dirty. Replace or clean CD.
� Shuf�e is active. Quit shuf�e mode
Poor cassette sound quality� Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
� Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
Recording does not work� Cassette tab(s) may be broken.Apply a piece of
adhesive tape over the missing tab space.
13 |
ACEC
PHILIPS
