XP AZ1145/00-1 08-05-2000 15:42 Pagina 6
AZ 1145 /00 page 6
BASIC FUNCTIONSGENERAL INFORMATION
EnglishSwitching on and off
Y Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE/OFF.OTFAFPELBAOTWTCDTUNER
DBBVOL
Y The set is switched off when the POWER slider is in the D B YBNAOASMSOSICT
PAUSESTOPYOPEN
TAPE/OFF position and the keys on the tape deck are released.SEARCHPLAY
PLAYYPAUSERECORD
" The volume and tuner presets will be retained in the set'sCD
PROGRAMREMOTESENSOR
REPAEALTL
memory.
Adjusting volume and sound
1. Press the VOL +, � controls to increase or decrease volume
CD
(or press 3 or 4 on the remote control).OTFAFPELBOAWTTTUNER
DBBVOL
2. Adjust the DBB control to select dynamic bass boost on or off. D YB BNAASOSOMSICT
PAUSESTOPYOPEN
SEARCH
PLAYYPAUSEPLAYRECORD
PROGRCAMREPEAATLLDREMOSENSORTE
PHILIPS demo mode
1. On the set, press the CD STOP 9 button for 5 seconds. D YB NABSOAOMSISCT
PAUSESTOPYOPEN
SEARCH
" PH..IL ..IPS scrolls across the display continuously.PLAYYPAUSEPLAYRECORD
2. To return to the current display you can either:PROGRACMDREMOTESENSOR
REPEAALTL
Y press any function button on the front panel. This interruptsCD M
EODSEARCH
STOP
the demo mode for 30 seconds;
PROGRAM
Y press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
Y Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
Y To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
Y Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
Y The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
6 |
ACEC
PHILIPS
