TROUBLESHOOTING
IMPORTANT :
If a fault occurs, first check the points listed below before taking the set for repair. If you areModifications not authorized by the manufacturer may void users authority to oper-
unable to remedy a problem by following these hints, consult your dealer or service centre.ate this device.
WARNING: Do not open the set as there is a risk of electric shock! Under no Note:This equipment has been tested and found to comply with the limits for a
circumstances should you try to repair the set yourself, as this will invalidate the Class B digital device,pursuant to part 15 of the FCC Rules.These limits are
warranty.designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates,uses,and can radiate radio
frequency energy and,if not installed and used in accordance with the instruction
No sound /powermanual,may cause harmful interference to radio communications.However,there is
� Volume not adjustedindicationno guarantee that interference will not occur in a particular installation.If this equip-
Y Adjust the VOLUMEment does cause harmful interference to radio or television reception,which can be
� No CD inserted
� Power Cord not securely connectedY Inserted a suitable discdetermined by turning the equipment off and on,the user is encouraged to try to cor-
Y Connect the AC power cord properly� CD badly scratched or dirtyrect the interference by one or more of the following measures :
� Batteries flat / incorrectly insertedY Replace/ clean CD, see Maintenance
Y Insert (fresh) batteries correctly� Relocate the receiving antenna.
� Laser lens steamed up
� Headphones connected to the setY Wait until lens has cleared� Increase the separation between the equipment and receiver.
Y Disconnect headphones� Connect the equipment into an outlet on a circuit different from that to
� Electrostatic discharge/interferenceThe CD skips trackswhich the receiver is connected.
Y Unplug the set. If batteries inserted, remove batteries� CD damaged or dirty� Consult the dealer or an experienced radio/TV technician for help.
from the battery compartment. Press and holdY Replace or clean CD
STANDBY ON y for 10 seconds, then re-plug /� shuffle or program is active
replace battery supply, and try activating the setY Switch off shuffle / program
again.
� CD contains non-audio filesSound skips during MP3 playback
Y Press SEARCH or §. once or more to skip to� MP3 file made at compression level exceeding
a CD audio track, instead of the data file320kbps
Y Use a lower compression level to record CDCanada
Poor sound quality in GAME AUX modetracks into MP3 format
Y Adjust the volume on the set or on your game EnglishPhilips
console� Disc damaged or dirty
Y Replace or clean discThis digital apparatus does not exceed theAZ2538
Severe radio hum or noiseCannot find desired MP3 titleClass B limits for radio noise emissions from
� Electrical interference: set too close to TV, VCR or� Wrong file extension used and/ or file namedigital apparatus as set out in the Radio
with unsuitable text characters used
computer
Y Move the set to increase the distanceY Make sure the file names are typed in EnglishInterference Regulations of the Canadian
text characters an that the MP3 files end with
Department of Communications.
Remote control does not function properly.mp3
� Batteries flat/ incorrectly insertedis displayed in USB PC LINKFranŤais
Y Insert (fresh) batteries correctly
mode for more than 10 scondsCet appareil numŽrique n'Žmet pas de bruits
� Distance/ angle between the set too large
Y Reduce the distance/ angle� Check the connection between your PC and the set. IfradioŽlectriques dŽpassant les limites
necessary, please refer to the chapter Connecting to
applicables aux appareils numŽriques de
Poor radio receptionUSB PC Link for the initial setup required.
Y Make sure the connected PC is turned on and theClasse B prescrites dans le RŹglement sur le
� Weak radio signalMusicMatch software is working.
Y FM / AM: Adjust the FM / AM telescopic aerialBrouillage RadioŽlectrique ŽdictŽ par le Mi-
nistŹre des Communications du Canada.
indication
� CD-R(W) is blank/ not finalized
Y Use a finalized CD-R(W) |
ACEC
PHILIPS
