Glass Shelves
General
1. Wash surfaces with 4 tablespoons baking soda
dissolved in 1 quart warm water and a soft, clean
!
cloth. Caution
2. Rinse surfaces with warm water. Dry surfaces with a
To avoid personal injury or property damage, handle
soft, clean cloth.
tempered glass shelves carefully. Shelves may break
? Do not use the following items:
suddenly if nicked, scratched, or exposed to sudden
- abrasive or harsh cleaners, ammonia,
temperature change.
chlorinebleach, etc.
- concentrated detergents or solventsRemove shelf by lifting front, releasing hooks from metal
- metal scouring padstrack then pulling out. Place shelf on a towel. Allow shelf
These items can scratch, crack and discolorto adjust to room temperature before cleaning.
surfaces.
Clean crevices by completing the following steps:
? Do not place buckets, shelves, etc. in dishwasher.
1. Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let set for 5 minutes.
Odor Removal
2. Spray warm water into crevices using faucet spray
1. Remove all food and turn power disconnect switch to
attachment.
off position.
3. Dry shelf thoroughly and replace shelf by inserting
2. Clean all interior surfaces including ceiling, floor, and
hooks into metal track and lowering front.
walls according to General instructions. Pay special
attention to corners, crevices, and grooves. Include all
Door Stop Adjustment
drawers, shelves, and gaskets.
1. Remove center grille blade from top air grille.
3. Turn power disconnect switch to on position and
2. Remove top air grille by removing (4) 1" screws with
return food to refrigerator. Wash and dry all bottles,
a magnetic screw driver. Pull assembly forward.
containers and jars. Foods should not be stored
3. Open refrigerator door so door stop arm and shoulder
uncovered in refrigerator. Wrap foods or place in
screw are accessible. Shoulder screws should be in
sealed containers. Sealing food retains moisture and
110° door opening position.
flavor while preventing odor transfer to other food
4. Remove shoulder screw and place shoulder screw
items. After 24 hours, check if odor was eliminated.
in the 90° or 120° door opening position.
Complete the following steps if odor was not eliminated.5. Replace air grille assembly.
4. Complete steps 1-2.
5. Place humidity controlled crispers on top shelf ofA
refrigerator section. Pack refrigerator and freezerE
sections including doors with crumpled sheets of
black and white newspaper.B
D
6. Place charcoal briquettes randomly throughout
newspaper.
C
7. Close doors and let stand 24-48 hours.
8. Remove charcoal briquettes and newspapers.
9. Complete steps 2-3.
Contact Consumer Affairs Department if odor was still not
eliminated.
Adhesives
A. 120° door opening position
1. Remove glue residue by rubbing toothpaste intoB. 110° door opening position
adhesive with fingers until adhesive loosens.C. 90° door opening position
D. Stop arm
2. Rinse surface with warm water. Dry surface with a
E. Shoulder screw
soft, clean cloth.
View of top hinge from top
Door Gaskets
1. Clean door gaskets every 3 months according to
General instructions.
2. Apply a light film of petroleum jelly to keep gaskets
pliable.
9 |
ACEC
WHIRLPOOL
