INSTALLATION
IMPORTANT: Save these instructions for the local electrical inspector?s use.
TOOL LIST Place the bottom of the template on a level base line,
34-l/8? above the floor. This will position the open oven
The following tools are needed to install your new oven
door about 37? above the floor.
1. l/8? drill bit
It is important that the oven be installed at or above the
2. Electric or hand drill minimum height specified. The unit has been tested and
3. Flat bladed and Philips screwdrivers approved, in accordance with safety standards, at this height.
The vent area may get hot when the oven is in use. Following
4. Pencil
these installation instructions will move the vent area out of
5. Ruler or tape measure and straight edge
a range where it would likely be touched by small children.
6. Hand saw or saber saw
The oven may be supported by either a solid bottom or two
LOCATION runners, on 11? centers. The solid bottom or two runners
should be34-118?above thefloor, levelwiththe bottom edge
Cabinet space must be provided to enclose the recessed
of the cutout opening.
pat-t of your built-in oven. See Figure 1 for all necessary
dimensions. A cutout 22-l/2? wide by 27.7/8? high must be Be sure the oven support is solid enough to support 150
made in the cabinet front. It is best to make a template to pounds. Also, be sure the oven support is level and straight.
insure accurate cutting. There is no way to le\?l the oven after installation.
OVEN AND CY?TOUT
DIMENSIONS
WOOD SCREWS
SECURE UNIT
TO CABINET
-f
27-710"
BOX
i
34-118" MIN.
1
23-314"
ON 11? CENTERS
Fig. 1
2 EINS17 |
ACEC
WHIRLPOOL
