POWER CONNECTIONS
Connecting power to BassPro is Use at least #12 AWG wire for theRoute all power wires through a grom-The remote (REM) connection requires
shown in Figure 7. Please observe Positive Battery (BATT +12) and Groundmet in the vehicleOs firewall. If a factorya +5 to +12 Vdc signal for BassPro
the following installation tips:() connections. If needed, use atgrommet is not available, install one.to turn on when using the line-level
least #20 AWG wire for the remoteConnect a short ground wire fromconnections. Most head units with
When using the high-level input con-(REM) turn-on connection.BassProOs ground terminal ( ) to thepreamp outputs provide this remote
nections, BassPro will automaticallynearest bare metal surface. For a goodvoltage signal. As an alternative,
turn on when you turn on your radio. Connect BassProOs OBATT +12V� connection, use sandpaper to clearconnect this terminal to a switched
In this case, the remote (REM) con-terminal directly to the batteryOs posi-paint from the metal surface and use ignition circuit.
nection is not needed. Use at least #20tive (+) terminal. Install a fuse holder,a screw with a lock (star) washer.
AWG speaker wire for speaker-levelwith a 20A fuse, within 18" of the bat-
input connections.teryOs positive (+) terminal.
Chassis GroundChassis Ground
(Bare Metal)(Bare Metal)
Fuse 20 AFuse 20A
18"
18"
BatteryBattery
RemoteRemote
Turn-On
Turn-On
BassPro
BassPro(Connection Panel)
(right-side panel)
Figure 7.
Source UnitSource Unit
4 |
ACEC
HARMAN KARDON
