TM
Chiller Fresh control is located below front shelf trim.
TM
Garden FreshCrispersControl adjusts amount of air circulating around drawer.
TM
Garden Freshcrispers keep produce fresh longerSlide control to . WrapCOLD for normal refrigerator temperature
produce tightly. Do not wash produce before placing inand to COLDER for colder temperature. Ice crystals may
crispers. Excess moisture could cause produce to spoilform on drawer or food on COLDER setting. Cold air
TM
prematurely. Do not line crispers with paper towenterelsing the Chiller F. Paper drreshawer can decrease
towels retain moisture.refrigerator temperature. Fresh Food control may need to
be adjusted to a lower number to compensate for colder
TM
Garden Freshcrispers control is located below front
air.
shelf trim. Control adjusts humidity in crisper drawers.
TM
Slide control to high for produce with leaves such asChiller Fresh drawer can be moved from the left to the
lettuce, spinach or cabbage. Slide control to low forright side of the refrigerator compartment to accomodate
produce with skins such as cauliflower, corn or tomatoesdifferent stor.age needs. To move drawer perform the
following steps:
Remove shelf and crisper drawers by completing the
1. Remove drawer by lifting and pulling out. Remove
following steps:
shelf by lifting from front, releasing hooks from metal
1. Open left crisper.
track, then pulling out.
?For doors hinged on left, open right crisper.
2. Remove plastic cap from back wall of Fresh Food
section by placing a knife covered with masking tape
CAUTION:
!
underneath cap and pulling forward.
Handle tempered glass shelves carefully to avoid3. Rotate boot 180° to opposite side.
personal injury or property damage. Shelves may break
4. Insert plastic cap in opposite side of Fresh Food
suddenly if nicked, scratched, or exposed to suddensection. Confirm cap is snugly in place. Cold air
temperature change.
may cause food to freeze if cap is not replaced.
5. Replace shelf by inserting hooks into metal track and
2. Remove glass crisper top by gently pushing up from
lowering the front. Use slots 4 though 6 only.
underneath. Tilt one end up and pull out.
6. Replace drawer by sliding in. Make sure boot fits
Glass crispersnugly over air inlet in back wall.
top
Air
Chiller Fresh System
inlet
installed on left side of Boot
refrigerator
Plastic
cap
Chiller Fresh
Metal
control
track
3. Remove left crisper by lifting from front while
Chiller Fresh System
supporting underneath and pulling out. For doorsAir
installed on right side of
inlet
hinged on left, remove right crisper.
refrigerator
Plastic
4. Remove support post at recess in bottom center ofBoot
cap
Fresh Food section.rotated
5. Remove other crisper by sliding to opposite wall. Lift180°
from front while supporting underneath and pull out.
6. Replace crispers and shelf by performing steps 2-5
in reverse order.
TM
Chiller Fresh System
(some models)
TM
The Chiller Fresh System features a drawer inside a
sleeve. Freezer air circulates between drawer and
Chiller Fresh
sleeve. This systems keeps food fresh longer and up to
control
5°F (3°C) colder than refrigerator temperature.
9 |
ACEC
WHIRLPOOL
