SERVICING
Certain problems are due to lack of simple mainteThe machine is noisy -
nance or oversights and can be solved easily without
having to call out an engineer. nThe dishes are rattling against each other.
nThe spray arms are knocking against the dishes.
The machine will not start
nThe door has not been properly closed. The dishes are not quite dry
nThe plug is not properly inserted in the power socket.nThe dishes have been left too long inside the
machine.
nThere is no current at the socket. Check the fuse.
The door is difficult to close
The machine will not fill with water
nThe dishwasher is not level or is not properly built-in.
nThe water tap is shut.
nThe water supply has been cut off.
If, after the above checks, the fault persists, call your
nThe inlet hose is kinked.
nearest Service Centre, indicating the fault, the appli-
nThe water inlet hose filter is clogged. ance model (Mod.), the product number (Prod. No.)
and the serial number (Ser. No.). This information can
be found on the rating plate located on the right-
hand side of the dishwasher door (see picture).
The machine will not drain
nThe drain hose is kinked.
nThe sink drain is blocked.
nThe drain hose extension is not correct.
nThere is no air vent in the end of the drain hose.
Prod.No. ........Ser. No. .........
Mod. ........
RA01
The dishes are not clean (poor wash)
nThe baskets are too full.
nThe dishes have not been arranged properly.
nThe spray arms do not rotate.
nThe spray arm holes are clogged.
n The water inlet funnel in the centre of the upper
basket is covered by dishes.
nThe filters are clogged.
nThe filters are not in position.
nNot enough detergent has been used or it is un-
suitable.
nThe detergent is old or has gone hard.
nThe washing programme selected is too gentle.
Visible lime deposits or white film on the
dishes
nThe rinse aid has run out or too little is being used.
PRA26GB
13 |
ACEC
OTHERS
