Maintenance and cleaning
Clean the external surfaces of the machine and control panelAttention!
with a damp soft cloth. If necessary use only neutralUnder no circumstances may the dishwasher be used without
detergents. Never use abrasive products, scouring pads orfilters.
solvent (acetone, trichloroethylene etc....). Incorrect repositioning and fitting of the filters will produce
Ensure that the seals around the door, the detergent and rinsepoor washing results.
aid dispensers are cleaned regularly with a damp cloth.
We recommend the use of Finish Dishwasher Cleanerevery
3 months or run a 65!C wash programme without dishes usingNEVER try to remove the
detergent.upper spray arm.
Regular use of Finish Dishwasher CleanercleansIf residues of soil have
inaccessible parts, eliminates unpleasant food odours andclogged the holes in the
helps prevent the build-up of limescale.upper spray arm, remove
them with a cocktail stick.
Cleaning the filters
The filters must be checked and cleaned from time to time.
Dirty filters will degrade the washing result.
1.Open the door, remove the lower basket.
2.The dishwasher filter system comprises a coarse filter (A),
a microfilter (B) and a flat filter (C).
Unlock the filter system using the handle on the microfilter,
and remove.Prolonged periods of non-operation
If you are not using the machine for any period of time you are
advised to:
1.Unplug the appliance and then turn off the water.
2.Leave the door ajar to prevent the formation of any
unpleasant smells.
3.Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location where the temperature
is below 0!C. If this is unavoidable, empty the machine, close
the appliance door, disconnect the water inlet pipe and empty
it.
1
3.Turn the handle about /4 a turn anticlockwise and remove.
Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
2.Turn the water tap off.
3.Remove the water inlet and discharge hoses.
4.Pull the machine out together with the hoses.
MA39
Avoid over tilting the machine during transportation.
4.Take hold of the coarse filter (A) by the handle with the hole
and remove from the microfilter (B).
5.Clean all filters thoroughly under running water.
6.Remove the flat filter (C) from the base of the washing
compartment and clean both faces thoroughly.
7.Put the flat filter (C) back in the base of the washing
compartment.
8.Place the coarse filter (A) in the microfilter (B) and
press together.
9.Put the filter combination in place and lock by turning the
handle clockwise to the stop. During this process ensure
that the flat filter does not protrude above the base of the
washing compartment.
13 |
ACEC
TRICITY BENDIX
