SymptomPossible causes
The door will not openThe programme is still running.
The door lock has not yet released
The water level in the drum is too high or the machine is heating.
Spinning starts late or the machineThe electronic unbalance detection device has cut in because the
does not spinlaundry is not evenly distributed in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times before the load is evenly distributed and spinning can resume
eventually at a lower speed. If the wash load is still not sufficiently
distributed, after 10 minutes, the machine will not spin. In this case,
redistribute the load manually and reselect the spin programme.
The machine makes an unusualThe noise produced when spinning may differ from your previous
noisewashing machine, which is due to the modern drive system. This new
motor ensures a softer start and more even distribution of the laundry in
the drum when spinning, as well as increased stability of the machine.
No water is visible in the drum Machines based on modern technology operate very economically
using very little water without affecting performance.
If after the above checks, there is still a fault , call yourCustomer care
local Bendix Service Force Centre.
For general enquiries concerning your Bendix appliance
or for further information on Bendix products, please
Service & Spare Partscontact our Customer Care Department by letter or
telephone as follows:
If you require an engineer or wish to purchase spare
parts contact your local Bendix Service Force Centre by
telephoning:Customer Care Department
Bendix
08705 929929
55-77 High Street
Slough
Your telephone call will be routed to the Service Force
Berkshire
Centre covering your post code area.
SL1 1DZ
Tel 08705 950950 *
* Calls to this number may be recorded for training
purposes
When you call the Service Force Centre please make
Mo..........d.
sure you give the model and serial number of theSer.
appliance.
This information can be found on the rating plate (see
picture).
In-guarantee customers should ensure that the aboveMod. ..........
Prod. No. ...........
checks have been made as the engineer will make a
Ser. No. .........
P0042
charge if the fault is not a mechanical or electrical
breakdown. Please note that proof of purchase is
required for any in-guarantee service calls.
21 |
ACEC
TRICITY BENDIX
