Re-recording only a mistake (Punch-in/out)
Repeatedly Recording Over the How to Record
Same Location (Loop Recording)As an example of use, the explanation below assumes you
are using the auto punch in/out to re-record a portion of
The repeat function (p. 49) allows you to play a certain track 1, which is a track to which you have already recorded.
portion of a song (the loop portion) over and over again.
1. Press REC TRACK [1].
If you used auto punch in/out together with the repeat
function, the portion will be repeated so the result of the REC TRACK [1] lights alternately in orange and green.
recording can be heard right away. 2. Place the fader for track 1 at the location shown below.
If the recording did not sound as you wished, simply press fig.01-309
[REC] and redo the recording.
Using the repeat function and auto punch in/out together in
this manner to repeatedly perform recording is known as
Oloop recording.�
* For details on how to set the portion where recording will
3. Use the repeat function (p. 49) to repeat the playback of
occur (the portion between the punch-in and punch-out the song and adjust the volume of the input source
positions), refer to OAuto punching in and out� above.
using the INPUT LEVEL knob.
Listen to the track you will be re-recording and the input
Setting the portion to be repeatedsource and adjust the volume of the input source so that
it is the same level as the track.
Before you begin recording, you will need to set the starting
and ending position of the portion to be repeated.4. Press [STOP].
* The portion to be repeated should contain the portion that you 5. Press AUTO PUNCH [ON/OFF].
wish to re-record (the portion between the punch-in and The indicator lights, showing that the auto punch in and
punch-out points).out have been set.
fig.01-308
Repeat6. When you are ready to record, press [REC], then press
[PLAY] to begin recording.
PlaybackRecordingPlaybackAfter you press [PLAY], you can record from the time
the first punch-in is reached until the time the punch-out
Timeis reached. Re-record the portion as desired.
When the song is repeated, you can check the result of Repeat StartPunch-InPunch-Out Repeat End
what you just recorded. If the recording is not (A)(B)
satisfactory, press [REC] and perform the recording
If the portion to be re-recorded is not fully contained in the again.
repeat portion, the recording may not start or end as desired.
7. Press [STOP] to stop recording.
* During updating, OKeep power on!� appears in the upper line
of the display, while the lower line shows what is being
processed.
8. Press [REPEAT] to make the button indicator go dark.
9. Press AUTO PUNCH [ON/OFF] to make the indicator
go dark.
54 |
ACEC
BOSS
