Main Menu (continued)
SYSTEM CONFIG
The underlined values are factory preset setting values.
Sub menuSettingsExplanation
SUB WINDOW<FULL>Used to select the type of sub window.
<PART><FULL>
<WFM>Used to reduce the whole input signal screen, and arrange it
horizontally when it is displayed.
<PART>
Used to cut out the central section of the input signal screen, and
arrange it horizontally when it is displayed (Displayed at the same size
as the previous screen).
<WFM>
*2
Used to display the waveform display screen.
WFM POSITION<LB>Used to set the WFM display position.
<RB><LB> Bottom left of the screen<RB> Bottom right of the screen
<RT><RT> Top right of the screen<LT> Top left of the screen
<LT>
MENU <CENTER>Used to set the on screen menu display position.
POSITION<LB><CENTER> Center of the screen
<RB><LB> Bottom left of the screen<RB> Bottom right of the screen
<RT><RT> Top right of the screen<LT> Top left of the screen
<LT>
ROTARY <CENTER>Used to set the picture adjusting knob status (on screen menu) display
POSITION<LB>position.
<RB><CENTER> Center of the screen
<RT><LB> Bottom left of the screen<RB> Bottom right of the screen
<LT><RT> Top right of the screen<LT> Top left of the screen
STATUS DISPLAY<CONTINUE>Used to set the input signal status (on screen menu) display status.
<3SEC OFF><CONTINUE> Displayed normally.
<OFF><3SEC OFF> After changing status, it is displayed for approximately
3 seconds, and then disappears.
<OFF>Not displayed.
SETUP LOAD<FACTORY>The saved factory preset setting values (FACTORY) or the user data
*1
<USER1> (USER 1-USER 5) are loaded. Also after loading user data, the screen
*1
<USER2> displays the signal selected before loading data.
*1
<USER3>
*1
<USER4>
*1
<USER5>
SETUP SAVE<USER1>Up to 5 sets of user data can be saved (J page 12).
<USER2>The menu settings and picture adjusting knob adjustment values
<USER3>(PHASE /CHROMA /BRIGHT /CONTRAST) excluding ?SETUP SAVE/
<USER4>SETUP LOAD? are saved.
<USER5>
FAN MOTOR<OFF>Used to set fan operation.
<ON><OFF>The fan is stopped. The brightness of the backlight
automatically lowers.
<ON>The fan operates. The backlight brightness returns to
normal.
*1 When the monitor is shipped from the factory, ?USER1? - ?USER5? and ?FACTORY? all have the same details.
*2 This screen is not displayed when ?RGB-COMP.? is selected in the ?YPBPR/RGB? menu in the ?INPUT SELECT?
menu.
g About H/V DELAY
This displays the video blanking period. By pushing the button, you can switch through the H blanking display J
V blanking display J H and V blanking display J no blanking display.
18
ACEC
PANASONIC
