http://getMANUAL.com
BVM-D20F1A/D20F1E/D20F1U/D24E1WA/D24E1WE/D24E1WU
B Adjusting the Color Temperature
N COLOR TEMP ADJ Menu
OverviewStructure of the COLOR TEMP ADJ Menu
The color temperature is adjusted with the COLORBefore adjusting the color temperature
TEMP ADJ menu. The color temperature can be set
Level 1Level 2Level 3Level 4Level 5Level 6
either commonly to all channels (STD, COL1 and
We recommend that you perform the automatic
COL2 menus) or individually for each channel (CHadjustment using the AUTO menu [A12] of the
STD B1MANUAL B11ADJUST
Chapter 2 MenuSET menu).CONTROL PRESET ADJ menu before adjusting theCOL1ORIGINAL VALUEChapter 2 Menu
Use the factory setting value or the adjusted value ascolor temperature.COL2SIGNALINT
an original value to shorten the adjustment time.CH SETEXT
PROBE B12SONY BKM-14L B121ADJUST B1211START B12111SET PROBE
Color temperature adjustment can be made in theON CRT
ANALYZE B1212X
following four ways:GRASEBY SLS9400Y
MINOLTA CA-100LOW LIGHT (20IRE)
Y Knob adjustment (MANUAL menu)PHILIPS RM5639HIGHLIGHT (100IRE)
You can adjust the color temperature with the biasTHOMA TF6 B122START B12111 D65
XD93
and gain knobs.
YSET PROBE
LOW LIGHT ON THIS CRT B12121X
Y Automatic adjustment using a probe(20IRE)Y
(PROBE menu)HIGHLIGHT (100IRE)SET PROBE ON CRTL
You can use the following probes for automaticD65
adjustment of color temperature. Except for the SonyD93
BKM-14L, a cable is required to connect the colorCOPY FROM B13
OTHER VALUE B131STD
analyzer to the monitor.
COL1
ManufacturerProbe Model NameCOL2
SONYBKM-14L (no cable required)CH SET
D65
GRASEBYSLS 9400D93
MINOLTACA-100
OTHER MONITOR B132MONITOR STD
PHILIPSPM 5639ADDRESS B1321COL1
THOMATF6COL2
CH SET
For more information about the cable specification required
STD
and about the connection, see OConnection CableMEMORY CARD B133FILE NAME B1331
COL1
Specifications for Color Temperature Probes� on page
COL2
66.TRIM B14ADJUST
TRIMCH SET
SIGNAL
Y Copying other data (COPY FROM menu)
You can copy data from other channels, common
data, or other BVM-DxxE/DxxF series monitors that
have been connected via the serial remote connector,
or from data stored in monitor memory cards.
Note
Data copy is impossible between monitors other than
BVM-DxxE/DxxF series.
YFine adjustment after the color temperature
adjustment (TRIM menu)
You can perform fine adjustment of the gain and bias
and add the data to the original adjustment data.
3031
1-19 |
ACEC
SONY
