Automatic TAutomatic Tuning Procedureuning Procedure
SIGNAL QUALITY - If poor or noisy signals are experienced from your TV during normal
operation, fit the supplied Relay RF cable between your VCR and TV. This measure will improve
the picture quality on your TV.
To automatically tune this TV to your local broadcasting stations follow the step by step guide below. Once
the TV has found all your local stations, then they are automatically assigned into the following order:
1.BBC1; 2: BBC2; 3: ITV; 4:CH4/S4C; 5: CH5 (subject to availability); 6: Satellite.
Alternatively, if you are familiar with local broadcasting frequency or CH numbers, then these can be
entered manually. Please refer to the Manual Tuning Procedure section of this booklet.
IMPORTANT NOTE: If you have a VCR or a Satellite receiver connected to this TV please ensure
that they are switched on before Autotune commences. In the case of a VCR, insert a
pre-recorded tape and begin playback of your equipment. With a Satellite receiver, select SKY
NEWS. These measures ensure that all your equipment is tuned in during the AUTOTUNE
procedure. (Satellite equipment installation is explained on Page 20 and 21).
Note: The VCR programme number should always be set to 0
Main Menu
Picture
Audio
Press and HOLD the MENU button until
Sound Mode1MAIN MENU with INSTALL is shown
Feature
Install
Highlight INSTALL using the up/down
buttons
2(if INSTALL is not shown follow step
above once more).=Select =Adjust Menu =Exit
Press the left right buttons select
INSTALL. The INSTALL menu is3
shown.
Install
Autotune
Manual Tune
Program SortIf language setting is incorrect, use
up/down buttons to highlight
4LanguageEnglish
LANGUAGE, and select using the
left/right buttons.
Use the up/down buttons to highlight
5AUTOTUNE.
= Select = Adjust Menu = Exit
Use the left/right buttons to begin Autotune
6AUTOTUNE.00 VIDEO CH37 AV1
01 BBC1 515.25
02 BBC2 528.30
03 ITV 544.65
04 CH4 566.55
05 CH5 572.10
06 Sat 525.25
Menu = Exit
Completed Autotune example.
77 |
ACEC
HITACHI
