CP-S318(C3SM4) / CP-X328(C3XM4)
Caring for the air filter
The air filter should be cleaned about every 100 hours. If the LAMP indicator and
TEMP indicator blink red simultaneously, or a message prompts you to clean the air
filter when you turn on the unit, the filter needs to be cleaned. (See "Related
Messages" and "Regarding the Indicator Lamps" for details.)
Turn off the projector, and unplug the power cord
1
Apply a vacuum cleaner to
2
the top of the air filter cover
to clean the air filter
Air Filter Cover
Turn on the projector, and use the menu to reset the filter
3
timer
To reset the air filter timer, from the OPTION menu, select FILTER TIME.
(Depress the RESET button for at least 3 seconds while filter time is being displayed.
The reset menu then appear. Select RESET on the menu with the button.)
Lamp (Option Lamp: DT00511)
HIGH VOLTAGEHIGH VOLTAGE
HIGH TEMPERATUREHIGH TEMPERATURE
HIGH PRESSUREHIGH PRESSURE
Before replacing the lamp, check the serial number of the replacement lamp bulb (sold separately:
DT00511), then contact your local dealer. Before replacing the lamp, turn off the power, and
unplug the power cord, then wait at least 45 minutes, in order to ensure that the lamp is
is properly cooled. Removing the lamp bulb while it is still hot could cause burns, or cause the
lamp bulb to burst.
The LCD projector uses a glass lamp bulb. It is a mercury lamp with highWARNINGWARNING
internal pressure. High-pressure mercury lamps can break with a loud
bang, or burn out, if jolted or scratched, or through wear over time. Each lamp has a
different lifetime, and some may burst or burn out soon after you start using them. In
addition, when the bulb bursts, it is possible for shards of glass to fly into the lamp housing,
and for gas containing mercury to escape from the projector's vent holes.
.Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
. If the replace lamp indicator (see "Related Messages" and "Regarding the
indicator Lamps") comes on, replace the lamp as soon as possible. Using the
lamp for long periods of time, or past the replacement date, could cause it to burst. Do
not use old (used) lamps; this is a cause of breakage.
. If the lamp breaks soon after the first time it is used, it is possible that there are electrical problems
elsewhere besides the lamp. If this happens, contact your local dealer.
. If the lamp should break (it will make a loud bang when it does), ventilate the room well, and make
sure not to breathe the gas that comes out of the projector vents, or get it in your eyes or mouth.
. If the lamp should break (it will make a loud bang when it does), unplug the power cord from
the outlet, and make sure to request a replacement lamp from your local dealer. Note that
shards of glass could damage the projector's internals, or cause injury during handling, so
please do not try to clean the projector or replace the lamp yourself.
. Obey local ordinances when disposing of used lamps. In most cases, it is possible to dispose of used
bulbs in the same manner as used glass bottles, but in some cases, bulbs are sorted separately.
. Do not use the projector with the lamp cover removed.
20 |
ACEC
HITACHI
