CP-S318(C3SM4) / CP-X328(C3XM4)
4-6 Color uniformity adjustment
Preparations
1. Perform these adjustments after the white 6. To temporarily turn correction off, place the cursor
balance adjustment described in Section 4-5.on ?ON? in the Adjust Tone menu and press the [ ]
2. Make a color uniformity adjustment for the key. To turn it on again, place the cursor on OFF in
following four tones.the Adjust Tone menu and press the [ ] key.
MIN tone (approx. 4% input signal)7. Although this adjustment can also be made using
MID-L tone (approx. 14% input signal)internal signals, we will here use the [ENTER] key
MID-H tone (approx. 25% input signal)on the Remote control transmitter to select the
MAX tone (approx. 57% input signal)following two signals.
3. Place the cursor on the tone to be adjusted in the Solid monochrome adjustment color (use G
Adjust menu and press the [ ] key. This displays color adjustment when a color differential meter
the Adjust Tone menu at the bottom of the screen. is used).
Select the major adjustment lattice point No. and Solid white (use for adjustment other than
color, and then adjust them.above).
4. The major adjustment lattice point numbers (a 8. Reset color-shading correction before
total of 17 points) corresponds to the major adjustment.
adjustment lattice point positions in the diagram When 4 tones and all colors are to be reset,
on the right. The color uniformity of the entire place the cursor on [C.UNIF.] in the Adjustment
screen can be adjusted by adjusting the white menu, press the [RESET] key and select
balance for each of the points starting in order [DEFAULT].
from the low numbers. When only 1 tone is to be reset, place the
5. Adjustment point No.1 should not be adjusted, cursor on the tone to be reset, press the
because it controls the brightness of the entire [RESET] key and select [DEFAULT].
screen. Single tone and monochrome resets cannot be
performed.
Adjust menuMajor adjustment lattice point position
VID-AD141216
C. UNIF.LEVELMINV/6
DAC-PBLACKMID-L648
GAMMAMID-H
STRIPEMAXV/3
H/6H/3H/3H/6
Adjust Tone menu
1021311
ONNo. 1R 0G 0B 0
V/3
Major adjustment lattice point No.
OFF
759
V/6
151317
8 |
ACEC
