4. Install foam seal in the gap between air conditioner base and
cabinet. Push foam seal in at the sides and trim any excess
material.WARNING
Electrical Shock Hazard
APlug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
A.Foam seal
Do not use an extension cord.
5. Remove the 2 front panel screws from air conditioner base. Failure to follow these instructions can result in death,
6. Insert front tabs of front panel into top of cabinet and swing
front into place. fire, or electrical shock.
7. Attach bottom front of panel with front panel screws. Replace
control knobs (on some models).8. Plug into a grounded 3 prong outlet.
NOTE: Route power supply cord through notch in front panel.9. Press RESET on the power supply cord plug.
B
A
A.Front panel screws
B.Power supply cord notch
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the Do not try to operate your air conditioner in the cooling mode
best possible results. when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
This section explains proper air conditioner operation.operate properly.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Starting Your Air Conditioner
1. Remove clear protective film from front panel badge (on 3. Set the Fan Control to desired setting. See ?Fan Control? for
some models).your particular model later in this section.
2. Set the Exhaust control. See ?Exhaust Control (on some 4. Turn the Thermostat control to a mid-setting. See
models)? later in this section.?Thermostat? for your particular model later in this section.
9 |
ACEC
WHIRLPOOL
