Basic Operation
Initial System Start-Up
POWERRESETBe sure to press the RESET switch when using the unit
for the first time, after installing the CD changer, etc., or
after changing the car battery.
1Make sure that the power of the unit is off. If the power
is on, press and hold the POWER button for at least 3
seconds to turn off the unit.
2Press the RESET switch with a ballpoint pen, or any
other pointed object.ANGLE 89
Detaching the Front Panel
1Press and hold the POWER button for more than 3Turning Power On and Off
seconds to turn off the power.
1Press the POWER button to turn on the unit.
2Press the(Release) button at upper left side untilNOTE
the front panel pops out.The unit can be turned on by pressing any other button except
the eject c and CLK/TITLE button.
3Grasp the left side of the front panel and pull it out.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the POWER button for at least 3
seconds to turn off the unit.
NOTESNOTE
" The front panel may become hot in normal usage (especiallyThe first time power is turned on, the volume will start from level
the connector terminals on the back of the front panel.) This is12.
not a malfunction.
" To protect the front panel, place it in the supplied carrying
case.Display Angle Adjustment
Movable display
Attaching the Front PanelThe movable display may be adjusted to 3 different
angles depending upon user preference.
1First, insert the right side of the front panel into the
main unit. Align the groove on the front panel with the
projections on the main unit.1Press the ANGLE 89 button to adjust the angle of the
movable display.
2Push the left side of the front panel until it locks firmly
into the main unit.NOTES
" The display will close a half minute after the ignition key is
turned to the OFF position.
2" The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
11back on.
CAUTION
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
NOTES
movable display will get very warm under normal operating
Y Before attaching the front panel, make sure that there is noconditions. This is not a malfunction. Do not touch.
dirt or dust on the connector terminals and no foreign object
between the front panel and the main unit.
Y Attaching the front panel carefully, holding the sides of the
front panel to avoid pushing buttons by mistake.
5-EN |
ACEC
ALPINE
