Adjusting soundSetting the clock
You can select the following modes for adjusting sound
1Press and hold DSPL until the clock indicator
depending on the music you listen to: BASS (low
flashes on the display.
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).2Press + (to set hour) or � (to set minute), and then
turn Jog dial.
1Press SEL repeatedly to select the mode to be3Press DSPL.
adjusted.
Pressing SEL cycles through the modes. The
selected modeOs indicator appears.Displaying the clock
2Turn Jog dial to increase/decrease the level or to
1Press DSPL.
select on/off for the selected mode.To return to the former display, press DSPL again.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.RADIO OPERATION
Aligning the source levelsTuning in to a station
(Seek/Manual Tuning)
(Source Level Adjuster)
Volume may vary each time you change the sourceLO
mode. In this case, you can align each source modeOs
volume to almost the same level.
1Press Jog dial (PUSH-SOURCE) or TU (TUNER)
repeatedly to select the desired mode.
2Press DSPL while pressing SEL.
OLA 0� appears on the display.+/�TU (TUNER)
3Turn Jog dial to adjust the level.
Local indicatorStereo indicator
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
Band indicator FrequencyTUNER
1Turn off the unit.indicationindicator
2Press and hold DSPL until OLA --� appears on the
display.1Press TU (TUNER) repeatedly to select the desired
band (FM1, FM2, FM3, AM1, or AM2).
Note2*Press + (to move to higher frequencies) or � (to
You can restore the factory settings only for VOL, BASS,
move to lower frequencies) to tune in to a station.
TRE, BAL, FAD, and H-BASS, and aligned source
OSTEREO� appears on the display when an FM
volume levels.station is broadcasting in stereo, and receiving
conditions are good.
Setting the beep tone*Seek Tuning and Manual Tuning
Y Press and hold + or � until seek Tuning starts.
1Turn off the unit.The unit locates a station automatically (Seek Tuning).
2Press and hold SEL until ObEEP� appears on theY Press + or � repeatedly to search for a desired station
display.while increasing or decreasing the frequency step by
3Turn Jog dial to select on (level indicators appear)step (Manual Tuning).
or off (level indicators disappear).To stop Seek Tuning, press + or � again.
4Press SEL.
3 ENGLISH3 ENGLISH
001/CDC-237(GB)412/25/02, 6:19 PM
CDCX237-total-En-4
Black |
ACEC
AIWA
