CD-DP900H
ENGLISH
Sleep operation
6Press the TUNING/TIME ( or ) button to specify the minutes,
then press the MEMORY/SET button.
1Play back the desired sound source.
2Press the TIMER/SLEEP button repeatedly until "SLEEP" is dis-
played.
7The unit will enter the timer stand-by mode automatically.
To change the sleep time:
Whilst the sleep time is displayed, press the TUNING/TIME ( or ) button.
(Maximum: 3 hours - Minimum: 1 minute)
To cancel the timer playback/timer recording:
3 hours - 5 minutes 5-minute intervals
Press the ON/STAND-BY button to turn the power on.
5 minutes - 1 minute 1-minute intervals
8When the preset time is reached, playback or recording will start.
3Press the MEMORY/SET button.
The volume will increase gradually until it reaches the volume you were listening
at before your system enters the timer stand-by mode.4Your system will enter the power stand-by mode automatically af-
9In timer playback:ter the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
If you select CD or TAPE, the unit will enter the stand-by mode after the play-1
back. If you select TUNER, it will enter the stand-by mode one hour after the tim-
To cancel the sleep operation:
er playback starts.
Press the ON/STAND-BY button whilst the sleep timer is set.
In timer recording:2
When the recording tape reaches its end, the timer recording will end, and the To confirm the remaining sleep time:
unit will enter the stand-by mode.Press the TIMER/SLEEP button whilst the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.- Timer and sleep operation -3
To reset or change the timer setting:Advanced Features
Perform "Timer playback or timer recording" from the beginning.Note:
Once the sleep time is set, it will remain unchanged until a new time is entered.4
Notes:
Once the time is set, the setting will be retained until a new time is entered.
When performing timer playback or recording using another unit connected to the 5
VIDEO/AUX sockets, select "VIDEO/AUX" in step 2.
At this time, only this unit will be turned on or enter the power stand-by mode auto-
matically. It will enter the power stand-by mode when the end of the recording tape 6
is reached in timer recording or 1 hour after the playback starts in timer playback.
However, another unit will not be turned on or off.
7
8
E-28
02/1/9CD-DP900H(H)_3.fm |
ACEC
SHARP
