xp CDR 600/00_01 English 06-04-2001 18:19 Pagina 13
Installation
Digital coaxial connections via a digital receiverPower supply/Mains
If you have a receiver with digital coaxial in- and outputs,these
connections allow you to make digital recordings from various
sources,connected to the receiver.English
DIGITAL
RECEIVER
1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
11
CDR
CD RECORDER2 Make sure all connections have been made beforeLL
CD RECORDER
RRswitching on the mains supply.
INOUT
ANALOGIDIGITALNOUTOPTIINCAL
3 Plug the power cord supplied into the AC MAINS ~
connector and the CD recorder, then into the wall socket.
4 Press ON/OFF.
1 Connect a digital coaxial cable between the DIGITAL IN-�The CD recorder will switch on.
and OUT sockets on the set and e.g. the (digital) AUX in-
Notes:
and output sockets on the digital receiver.
If the CD recorder is in Standby mode (red LED on),
�Any digital device,connected to the digital input sockets
press any key to activate the recorder.
of the digital receiver (e.g. CD and DVD) can now be
When the CD recorder is in the OOFF�position,it is still
used as recording source.
consuming some power.If you wish to disconnect your
CD recorder completely from the mains,withdraw the plug
from the AC Outlet.
13 |
ACEC
PHILIPS
