CD-RW5000H/CD-RW5000W
To exit the test mode
The unit returns to the normal operation through reset entry.
Table Character display for test mode 1
Character display
ItemTypeAuxiliary display 1 2 3 4 5 6 7 8 911 1012Auxiliary displayNote
Test mode nameI N I TIA L
Set-Up CompleteFunctionF I N I S H
In the destination display, a destination code is displayed. For the span display, "9" means 9 kHz/50 kHz, and "10" means 10/
100 kHz.
2. Soft reset
Purpose: To initialize the unit.
Function: To initialize all functions.
Operation: "ALL CLEAR" is displayed, all functions are initialized, and the unit is turned on.
To exit the test mode
When the initialization through soft reset is complete, the unit is turned on.
Table Character display for test mode 2
Character display
ItemTypeAuxiliary display 1 2 3 4 5 6 7 8 9111012Auxiliary display Note
Reset operationOperationA L LC L E A R
display
3. CD test mode (If this test mode is not activated, refer to CD troubleshooting on page 65.)
In the CD test mode, each step can be performed even if the LID-SW is off. However, if you cannot obtain a focus in step
3 or if other kind of error handling starts, you cannot proceed to the following steps. In error handling, press the POWER key
to exit the test mode, or press the STOP key to prohibit operations other than returning to step 1.
(1) Step 1 mode
In the CD test mode, the following display appears, CD initialization is performed, and you are prompted for data.
Reset operation display / Operation
"CD_TEST"
After lighting up for one second
"T1___________0:00"
The keys you can press here and the resulting operations are as follows:
"POWER" ........... The test mode is turned off, the power is turned off, and the unit is placed in the normal stand-by mode.
"FWD" ................ While holding down this key, the pickup moves outward after returning to the innermost track.
"REV" ................. While holding down this key, the pickup moves inward after returning to the innermost track.
"PLAY" ............... Jumps to step 2.
"STOP"............... Cancelled.
"TAPE REC" ...... Jumps to step 5.
* While the pickup is moving to the innermost track in the initialization, none of the keys except POWER is accepted. When PU-
IN SW ON cannot be detected in ten seconds, the unit stops the slide motor and shows the following error code. Then, you
can press the POWER key to exit the test mode, or the STOP key to return to step 1. You cannot perform other operations.
"E--CD01"
(2) Step 2 mode
When the "PLAY" key is pressed in the above mode, the laser is turned on. At this time, another operation must not be
performed.
Display "T2___________0:00"
The keys you can press here and the resulting operations are as follows:
"POWER" ........... The test mode is turned off, the power is turned off, and the unit is placed in the normal stand-by mode.
"FWD" ................. While holding down this key, the pickup is moved outward.
"REV".................. While holding down this key, the pickup is moved inward.
"PLAY"................ Jumps to step 2.
"STOP" ............... Returns to step 1.
"TAPE REC" ....... Jumps to step 5.
� 29 � |
ACEC
SHARP
