This product has been designed and manufactured according to
FDA regulations Otitle 21, CFR, chapter 1, subchapter J, based onWARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCEthe Radiation Control for Health and Safety Act of 1968O, and is
TO RAIN OR MOISTURE.classified as class 1 laser product. There is not hazardous invisible
laser radiation during operation because invisible laser radiation
emitted inside of this product is completely confined in theCAUTION
protective housings.
The label required in this regulation is shown `.< Do not expose this apparatus to drips or splashes.
< Do not place any objects filled with liquids, such as vases, on
the apparatus.
< Do not install this apparatus in a confined space such as a
book case or similar unit.
< The apparatus draws nominal non-operating power from the
AC outlet with its POWER switch in the off position.
< The apparatus should be located close enough to the AC`For U.S.A.
outlet so that you can easily grasp the power cord plug at
any time.
< An apparatus with Class ! construction shall be connected to
an AC outlet with a protective grounding connection.
< DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO
EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS
ARE WITHIN!
< IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,Rear panel of the Subwoofer
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
Optical pickup:
< USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OFType: SF-P200Z
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAYManufacturer : SANYO Electric Co., Ltd
RESULT IN HAZARDOUS RADIATION EXPOSURE.
Laser output : Less than 0.5 mW on the objective lens
Wavelength: 765 - 815 nm
For U.S.A.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residentialFor CANADA
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used inAC POWER CORD CONNECTION
accordance with the instructions, may cause harmful
interference to radio communications. However, there is noCAUTION:
guarantee that interference will not occur in a particularTO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG
installation. If this equipment does cause harmful interferenceTO WIDE SLOT, FULLY INSERT.
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged toPour le CANADA
try to correct the interference by one or more of the following
measures:CORDE DE CONNEXION CA
Y Reorient or relocate the equipment and/or the receiving
antenna.ATTENTION:
Y Increase the separation between the equipment andPOUR ?VITER LES CHOCS ?LECTRIQUES, INTRODUIRE LA LAME
receiver.LA PLUS LARGE DE LA FICHE DANS LA BORNE
Y Connect the equipment into an outlet on a circuit differentCORRESPONDANTE DE LA PRISE ET POUSSER JUSQUOAU FOND.
from that to which the receiver is connected.
Y Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Changes or modifications to this equipments not expressly
approved by TEAC CORPORATION for compliance will void the
userOs warranty.
3 |
ACEC
TEAC
