3
Radio receptionFailur*e (Illuminates until any button is pressed.)
The connection of speakers/amplifiers is
Preset tuning is not possible.
incorrect.
Store the correct frequency in the memory.
tSee the installation guide manual of this
The broadcast signal is too weak.
model to check the connection.
The stations cannot be received.FAILURE*3 (Illuminates for about 1 second.)
The sound is hampered by noises.
When the XM tuner is connected, storing an
Connect a power antenna control lead (blue)
XM radio channel into a preset failed.
or accessory power supply lead (red) ttoBe th sue re to receive the channel that you
power supply lead of the car?s antenna
want to store, then try it again.
booster. (Only if your car has a built-in FM/
High Temp
AM antenna in the rear/side glass.)
The ambient temperature is more than 50°C
Check the connection of the car antenna.
(122°F).
The auto antenna will not go up.
tWait until the temperature goes down
tCheck the connection of the power
below 50°C (122°F).
antenna control lead.
1
Check the frequency.NO Disc*
When the DSO mode is on, the sound iNos d isc is inserted in the CD/MD unit.
sometimes hampered by noises.tInsert discs in the CD/MD unit.
tSet the DSO mode to ?OFF? (pageNO Mag23).azine
Automatic tuning is not possible.The disc magazine is not inserted in the CD
The local seek mode is set to ?on.?unit.
tSet the local seek mode to ?off? tInsert the magazine in the CD unit.
(page 21).NO Music*2
The broadcast signal is too weak.A CD which is not a music file is inserted in
tPerform manual tuning.
the MP3 playable CD unit.
The ?ST? indication flashes.tInsert a music CD in the MP3 playable CD
Tune in the frequency accurately.unit.
The broadcast signal is too weak.Offset
tSet to the monaural reception modThe ere may be an internal malfunction.
(page 21).tCheck the connection. If the error
A program broadcast in stereo is heard in indication remains on in the display,
monaural.consult your nearest Sony dealer.
The unit is in monaural reception moPudshe. Reset
tCancel monaural reception mode
The CD/MD unit cannot be operated because
(page 21).of some problem.
Interference occurs during FM reception.tPress the RESET button on the unit.
The wide mode is selected.
tSet the IF mode to ?IF-Auto? (pag*1eW2h1e)n th.e CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
Error displays/Messages*3 ?Failure? (small case) and ?FAILURE? (upper case)
are different messages.
Error displays
If these solutions do not help improve the
(For this unit and optional CD/MD changers)
situation, consult your nearest Sony dealer.
The following indications will flash for about 5
seconds, and an alarm sound will be hMeeasrsagd.es
Blank*1Local Seek +/-
No tracks have been recorded2 on. an MDTh*e local seek mode is on during automatic
tPlay an MD with recorded tracks ont iunit.ng (page 16).
1
Error*?? or ??
A CD is dirty or inserted up2. side down*You have reached the beginning or the end of
tClean or insert the CD correctly.the disc and you cannot go any further.
A CD/MD cannot play because of some
problem2.*
tInsert another CD/MD.
29 |
ACEC
SONY
