SERVICE ADJUSTMENTS
Note: Some items of the service adjustments for this chassis are controlled by the CPU, IC801, and the
adjustments are carried out by using the RC handset.
[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the service adjustments data for each circuit, therefore, when the memory IC is
replaced, it should be performed OOPTION SETTING� on previous page and the following adjustments, refer to
further adjustment on page 10.
ADJUSTABLE SERVICE ADJUSTMENT
REGULAR
Item No.OSD Description
1AGCAGC Adjustment
2CUTCut-Off Drive Adjustment
3GRYG-Drive Adjustment
4GRYB-Drive Adjustment
7HBPH-Blanking Phase Adjustment
8OSDOSD Positioning Adjustment
WIDE
Item No.OSD Description
1P V-PVertical Centre Adjustment
2P H-PHorizontal Centre Adjustment
5P V-SVertical Size Adjustment
6P H-SHorizontal Size Adjustment
7P PCCPcc Adjustment
8P TRPTrapezoid Distortion Adjustment
10P CNRCorner Adjustment
IMPORTANT NOTICE
Do not attempt to adjust service adjustments not listed on the above otherwise it may cause
loss of performance and product safety.
To enter to the Service Mode
+ Press and hold the GREEN button on the remote control and then press the Pt button inside of the door. The
adjustment window will appear on the screen.
ADJUST
REGULAR
WIDE
OTHERS
TB1251
SELECT:OK
EXIT : RECALL
-8-
C2KAV |