INSTALLATION
If this refrigerator featuring magnetic door seals isElectrical connection
to replace an older appliance having a spring lock
on the door or lid, be sure to make that spring lockBefore plugging in, ensure that the voltage and fre-
unusable before you discard the old appliance.quency shown on the serial number plate correspond
to your domestic power supply.
This will prevent it from becoming a death-trap forVoltage can vary by ?6% of the rated voltage.
a child.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Location
The appliance must be earthed.
The appliance should be installed well away fromThe power supply cable plug is provided with a con-
sources of heat such as radiators, boilers, direct sun-tact for this purpose.
light etc.If the domestic power supply socket is not earthed,
Best performance is obtained with ambient tempera-connect the appliance to a separate earth in compli-
ture between +18°C and +43°C (class T); +18°C andance with current regulations, consulting a specialist
+38°C (class ST); +16°C and +32°C (class N); +10°Ctechnician.
and +32°C (class SN).
The class of your appliance is shown on its ratingThe Manufacturer declines all responsibility if the
plate.above safety precautions are not observed.
Make sure that there is nothing hindering air circula-This appliance complies with EEC directive
tion at the back, bottom, or top of the appliance.number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
To achieve the best performance when the appliance
is set under a wall cabinet, the top of the applianceThis appliance complies with the following
E.E.C. Directives:
should be at least 15 mm away from the base of the-73/23 EEC of 19.2.73 (Low Voltage Directive) and
wall cabinet (A).
subsequent modiŢcations;
However, the appliance should ideally not be installed-89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
underneath wall cabinets (as shown in B).ity Directive) and subsequent modiŢcations.
Fig. 1
15mmCleaning the applianceOs interior
Before using the appliance for the Ţrst time, wash all
internal parts with lukewarm water and neutral soap
so as to remove the typical �newE smell and then dry
thoroughly.
AB
Do not use detergents or abrasive powders as these
will damage the Ţnish.
D175
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly level.
4 |
ACEC
CASTOR
