Speaker Wire Preparation and Connection
Once the proper hookup has been selected using the previous section, make the
physical connection using the following instructions.
Cables or Connecting Wire
To assure that the high quality signals produced by your Citation ampliŢer are car-
ried to your speakers without loss of clarity or resolution, we recommend that you
use high quality speaker cable. Many brands of cable are available, and the choice
of cable may be in�uenced by the distance between your speakers and the ampliŢer,
the type of speakers you use, personal preferences, and other factors. Your dealer
or installer is a valuable resource to consult in selecting the proper cable for
connections between your ampliŢer and speakers.
Regardless of the brand or type of cable selected, we recommend that you use a
cable constructed of Ţne, multi-strand copper with a AWG of 14 or larger.
Remember, that in specifying cable, the lower the number, the thicker the cable.
Cable with an AWG of 16 may be used for short runs of less than ten feet. We do
not recommend that you use any cables with an AWG equivalent of 18 or higher
due to the power loss and degradation in performance that will occur.
One way to insure that cables will deliver a predictable level of performance is to
¨
use cables that are Home THXcertiŢed. This certiŢcation assures that the cables
have met a rigorous set of speciŢcations designed for home theater applications.
Cables that are run inside walls should have the appropriate markings to indicate
listing with UL, CSA or other testing agency standards. Questions about cables
inside walls should be referred to your installer or a licensed electrical contractor
who is familiar with the NEC and/or the applicable local building codes in
your area.
Connections to Speakers
Regardless of the channel conŢguration used, the Ţnal step of the installation
process is to connect the ampliŢer to your speakers, using high quality cable, as
outlined above. A pair of binding posts is provided for each channel output. These
posts will accept bare wire, spade lugs or banana-type plugs where permitted by
local safety agencies.
If bare wire is used for the connections, strip approximately 1/2 inch to 3/4 inch
(20mm) of insulation from the end of each wire and carefully twist the strands of
each conductor together. Be careful not to cut the individual strands or twist them
off; for optimal performance, all strands must be used.
Then, loosen the knobs of the speaker output terminals, far enough so that the
pass-through hole is revealed. Note that one conductor of the speaker cable may
have no markings, and the other will have a red line, brand name markings, a black
thread, or some other positive indication. Follow the proper connection instruc-
tions for your system with regard to which terminals are used. The small speaker
17 |
ACEC
HARMAN KARDON
