MIXER QUICK SETUP
1. Make sure all items listed on the 9. Switch everything on in the
front of this guide are included following order.
in the box. " audio input sources (i.e.
2. READ SAFETY INSTRUCTION turntables or CD players)
BOOKLET BEFORE USING THE " mixer
PRODUCT. " last, any amplifiers or
3. Study this setup diagram. output devices
4. Place mixer in an appropriate 10. When turning off, always
position for operation. reverse this operation by,
5. Make sure all devices are turned " turning off amplifiers
off and all faders and gain knobs " mixer
are set to ?zero? " last, any input devices
6. Connect all stereo input sources 11. Go to http://www.numark.com
as indicated in the diagram. for product registration.
7. Connect the stereo outputs to
power amplifier(s), tape decks, More information about this
and/or other audio sources. product may be found at
8. Plug all devices into AC power. http://www.numark.com
REAR CONNECTIONS
1. Phono Inputs: This input is used for connecting 8. Master Output (RCA): This output is for
your turntables through the sensitive RIAA phono connecting an external monitoring device such as
preamplifiers. Only turntables with phono level a PA system, powered monitors or a home
output should be attached. Line level turntables stereo. The level of the master stereo output
must be attached to the line inputs. signal is controlled by the master fader.
2. GND: This screw connector should be used to 9. Stereo Balanced Master Outputs (XLR): low-
secure any turntables or other devices connected impedance XLR type connectors controlled by the
to the mixer that need to be grounded. Master fader.
3. Line Inputs: CD players, Tape Decks, Samplers 10. AC In: This mixer is designed to work with the
or other line level input devices should be power supply cord that comes with the unit.
connected to these inputs. While the power is switched off, plug the power
4. Microphone Input: Microphones with a 1? supply into the mixer first, then plug it into the
connector can be connected to these input outlet.
terminals. 11. Voltage Selector: Set this to the correct voltage
5. Fader Start Connector: to attach your mixer to for your location standard.
a remote start equipped Numark CD player using 12. Power Switch: Use this switch to turn on the
industry standard 1/8?(3.5mm) cables. mixer after all input devices are already
6. Record Output: This RCA output is for connected to prevent damage to your equipment.
connecting a recording device such as a tape Turn the mixer on before you turn on amplifiers
deck or CD recorder. The level of the record and turn of amplifiers before you turn off the
output is based upon pre-master levels. mixer.
7. Zone Output (RCA): This output is for
connecting an external monitoring device such as
a PA system, powered monitors or a home
stereo. The level of the zone stereo output signal
is controlled by the zone fader.
3 |
ACEC
NUMARK
