5. LCD DISPLAY- Indicates all the functions, as 12. BPM- Switches the mode of the display between
they are occurring, with the CD. showing the BPM and the percentage change in
6. OPEN/CLOSE- Pressing will open or close the pitch.
disc tray on the transport. 13. -,+ - Works as pitch bend and controls key and
7. SGL- To set play mode in single or continuous pitch functions.
play. 14. PITCH SLIDER- Controls the overall speed of
8. TIME- Controls display indication of time mode. the music.
9. PROGRAM- Depress this button and the unit will 15. PITCH RANGE LED- Indicates current pitch
stop and the program indicator will light. range of the pitch slider
Select each track to be programmed and press 16. LOOP IN- Used to set stutter and loop in points.
the PROGRAM button between selections. You 17. LOOP OUT- Used to set loop out points and
can program up to 30 tracks. Press PLAY to release the loop.
start the program. To exit and erase program, 18. RELOOP/STUTTER- Used for repeated play
either hold the program button down for more (stutter) from the loop in point, repeating a
than 2 seconds while the unit is stopped, open previously set, and hot start.
the disc tray, or turn off the power. 19. RELAY- Used for setting Alternating play start
10. TRACK SELECT/SEARCH- between attached units.
a. Rotation - selects tracks 20. TAP- Tap this button with the beat of the music to
b. Pressing while rotating - selects tracks determine the current Beats Per Minute (BPM).
21. CD Illumination Light (unit front) - lights up
+10
c. Pressing once- Puts wheel in search the CD drawer and CD when open.
22. CD Drawer (Unit Front) - Place your CDs you
mode.
wish to play in here. This unit is designed to
11. PITCH- actives the pitch slider and adjusts the
amount of control the pitch slider has on the overall play commercially available CD and properly
speed of music. Tapping the pitch will toggle slider burned and finalized CDR. Due to variances on
between 8% and 16% pitch ranges. Holding the the specification of certain CD burners and CDs
pitch for 3 seconds will deactivate the pitch control. some discs home made CDs may not play
properly.
23. Power Switch- Turn on and turn off the 29. Remote Start Connector - Use this connector to
machine with this button. The unit should plug into your fader start compatible mixer or
always be shut down with this button first remote switch. This function is always active.
before any external power is removed. To use this connector for fader start, connect
Typically, it is recommended that the CD player the supplied fader start cable to a fader start
is powered on before amplifiers and off after compatible mixer. Every time you move the
amplifiers to avoid an audio spike to be sent crossfader on the mixer over to the side that
through your equipment. the unit is on, it will automatically start playing.
24. IEC Power Plug Connector - Plug your supplied When you move the fader away from that side,
power cord in here. the unit will stop. Moving the fader back to the
25. Voltage Selector - Set this switch to the voltage unit side will start play again.
for your location.
26. RCA Audio Connectors - Connect your CD
player to your mixer from this line level output.
27. Digital Output - The format is type 2, form 1,
also known as S/PDIF (Sony/Phillips Digital
Interface Format). In order to use the digital
output you should not use variable pitch slider
and the pitch bend buttons. If you adjust the
pitch, other devices may not read the digital
output properly because the sampling rate
changes
28. Relay Connector- If you wish to use the relay
function plug in your 3.5mm stereo control
cables into here and then into your other unit.
The cable must be a stereo style plug for the
units to work properly |
ACEC
