Starting up
The TV sound is now transmitted via the Concer-
Activating sound Organising the speakers
tos components, in Concertos 2, the speakers in
playback via Concertos
the TV set become the centre channel. The satellite speakers (SL) each have an upper
and lower section that can be turned against
1. Switch the TV set on.N.B.: when playing sound back via Concertos,
each other. This means the sound emission from
the standard settings for sound are not active,
2. Launch the TV menu on your TV set each individual speaker in the room can be alte-
Mnor are settings for high, low and balance etc.
by pressing button M on the remote red so the system is best suited to and most flexi-
control.ble for conditions in the room.
TV menuSpeaker selectionThe lower section of each satellite speaker should
Standard settingsalways be organised in a way that the sound is
Picture1. Press the keys briefly on your emitted in the direction where the best surround
Sound
Connectionsremote control.sound can be produced, like perhaps the couch
PIP menuwhere you sit to watch TV.
2. With via "other..." select the
Settings
"Loudspeakers" option.The upper section can be turned more to or away
from the wall to vary the direction and intensity
iInfo
of the sound playback from each individual spea-
OKMBack
Night mode
EEndker.
Sound correction
1-channel operationIt is advised that you take a some time when it is
3. With the cursor keys on the quiet to try different settings until you have found Loudspeakers 2 3 5
remote control highlight the "Sound" those which best suit your expectations.Center
menu option and click OK.
SurroundBoth surround speakers that you have mounted
Volumeon the wall can be tilted downwards. For Sound
Sound viaTV HiFi-Stereo Concertos BOSE LS50Vexample, this should be carried out if the wall
Headphone volume
speakers have not been mounted at ear height.
Loudspeaker sound
Headphone sound3. With select the number of
To do this, using the adjusting key (JS), loosen
AV audio signal
speakers connected to the module
Autom. Vol. Contr.both hexagon bolts with which the mounting
and confirm with OK.
flange is screwed to the bottom of the wall
mount at both sides.
iInfo
OKMBack
Now insert the short end of the key into the screw
EEndSetting high and low
and loosen it. Use the long end of the key to loo-
sen the screw further.
The basic high and low settings can be tweaked
4. In the "Sound" menu highlight the ¨
with the Acoustimass module. To do this, first Once you have obtained the desired angle, tigh-
"Concertos" option in the "Sound
remove the shrouding cover from the back. With ten the screws again following the instructions
via" column with .
the knobs for treble and bass you can determine given above in reverse.
5. Close the menu by pressing the E but-the high and low playback settings.
E
ton. The settings have been saved.
16 |
ACEC
LOEWE
