The instructions given here are partial abstracts from the Operating InstructionSECTION 1
Manual. The page numbers shown reflect those of the Operating Instruction Manual.
GENERAL
Getting startedGetting StartedGetting StartedGetting Started
Warning on power connection
PrecautionsIdentifying Parts and Controls
Y Use an appropriate power cord for your local powerSee the pages in parentheses for further details.
Installationsupply.
For the customers in the U.S.A.FrontRear
Y Prevent internal heat build-up by allowing adequate airIf you do not use the appropriate cord, this monitor will
circulation. Do not place the monitor on surfaces (rugs,not conform to mandatory FCC standards.
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.Examples of plug types:
Y Do not install the monitor near heat sources such as
radiators or air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.
Y Do not place the monitor near equipment which generates
magnetism, such as a transformer or high voltage powerfor 100 to 120 V AC for 200 to 240 V AC
lines.
Y Before disconnecting the power cord, wait at least 30
seconds after turning off the power to allow the static
Maintenance
electricity on the CRT display surface to discharge.
Y After the power has been turned on, the CRT is
Y Clean the cabinet, panel and controls with a soft clothdemagnetized (degaussed) for about 5 seconds. This
N 5 Nlightly moistened with a mild detergent solution. Do notgenerates a strong magnetic field around the metal frame,1 MUTING button (page 7)8 AC IN connector
use any type of abrasive pad, scouring powder or solvent,which may affect the data stored on magnetic tapes andMutes the sound.Provides AC power to the monitor.
such as alcohol or benzine.disks near the bezel. Place magnetic recording equipment,
2 RESET button (page 15)
Y Do not rub, touch, or tap the surface of the screen withtapes and disks away from this monitor.9 Video input connector (HD15)EN
Resets the adjustments to the factory settings.
sharp or abrasive items such as a ballpoint pen orInputs RGB video signals and SYNC signals.
screwdriver. This type of contact may result in a scratchedThe outlet should be installed near the equipmentF3 GPE button (page 16)
picture tube.and be easily accessible.Selects the Graphic Picture Enhancement (GPE) mode.
SideES
4 MENU button (pages 7 -15, 17)
TransportationDisplays the MENU OSD.
C
When you transport this monitor for repair or shipment, use5 > (contrast) (?//) buttons (pages 7 � 15,
the original carton and packing materials.20)
Adjust the contrast.AUDIOIN
Use of the Tilt-SwivelFunction as the (?//) buttons when adjusting other
items.
With the tilt-swivel, this monitor can be adjusted to the6 ? (brightness) (./>) buttons (pages 7 �
desired angle within 180° horizontally and 20° vertically.15)
To turn the monitor vertically and horizontally, hold it atAdjust the picture brightness.
the bottom with both hands as illustrated below.
Function as the (./>) buttons when adjusting other
items.!1 AUDIO IN jack
15°Inputs audio signals when connected to the computerOs
90°7 u (power) switch and indicator (pages 17,audio out jack.
20)
90°Turns the monitor on or off.
The indicator lights up in green when the monitor is!� 2 Headphones jack
5°Outputs audio signals to headphones (not supplied).
turned on, and lights up in orange when the monitor is
in power saving mode.
CPD-220GS
45 |
ACEC
SONY
