Power on/off
Power on/off
WARNING yWhen the power is on, a strong light is emitted. Do not look into
the lens of projector. Also do not peep at the inside of projector through a hole.
NOTE Turn the power on/off in right order. Please power on the projector prior
to the connected devices. Power off the projector later than the connected devices.
Turning on the power
STANDBY/ON POWER
Make sure that the power cord is rmly and indicator
1. button
correctly connected to the projector and the
VIDEORGB SEARCH
outlet. ASPECTAUTOBLANK
ONMAGNIFYHOMEPAGE UPVOLUME
OFFENDPAGE DOWNMUTE
Remove the lens cover, and set the power FREEZEKEYSTONE
2.
switch to the ON position. POSITIONMENU
ENTER
The power indicator will light up in steady orange. ESCRESET
Then wait several seconds because the buttons
may not function for these several seconds.
Press the STANDBY/ON button on the projector or the remote control.
3. POWER
The projector lamp will light up and the POWER
indicator will begin blinking in green. When the power is (Steady orange)
completely on, the indicator will stop blinking and light in POWER
green.
(Blinking in green)
To display the picture, select an input signal according to
the section "Selecting an input signal" (&18).POWER
(Steady green)
Turning off the power
This product is able to turn off the main power during the cooling. However, please
pay special attention to below two points when you do:
(1) Please do not turn the projector on again for at least 1 minute in this case.
Neglect could shorten the lifetime of the lamp.
(2) During use or immediately after use, do not touch around the lamp and vents
of the projector (&4 I) It could cause a burn.
Press the STANDBY/ON button on the projector or the remote control.
1.
The message "Power off?" will appear on the screen for approximately 5
seconds.
Press the STANDBY/ON button on the projector or the
2. Power off?
remote control again while the message appears.
The projector lamp will go off, and the POWER indicator will
begin blinking in orange. POWER
Then the POWER indicator will stop blinking and light in (Blinking in orange)
steady orange when the lamp cooling is complete.
POWER
Make sure that the power indicator lights in steady orange,
3. (Steady orange)
and set the power switch to the OFF position. The POWER
indicator will go ofAttachf. the lens cover.
17 |
ACEC
HITACHI
