HITACHI CPX385W Repair Manual

$7.99

HITACHI CPX385W - It's a complete service manual, and it's in PDF format. It contains circuit diagrams ( schemas ) etc. It also usually contains parts catalog. After placing order we'll send You download instructions on Your email address. See below for delivery information

The manual is available only in language(s): English

Link to manual will be sent on Your email address after You place order.

This product was added to our catalog on Monday 07 May, 2007.

Reviews

Write Review

Buy & Download

Product Reviews

There are currently no reviews for this product.

Other reviews

John Craig - 07/31/2006

Very nice site and the manual is great. A life-saver. Thank you so much!

matt wilschke - 03/07/2008

Essential for popping the top open and cleaning and replacing what needs repalced. One note: the Ornamental Panel is attached with some adhesive as well as screws and faders so don't be shy about prying it open.

Carl Conti - 08/03/2006

Thanks for manual for Luxman M02. I'll recomend this site to my friends for sure! Keep on the good work!

Othmar Herbst - 01/13/2008

PDF contains : - schematics, but a little un-sharp. - disassembly instructions, accurate drawings - description of test-modes

Francisco Dorfman - 06/13/2007

I was thinking I will never find this manual. User-Manuals had saved my Teac V-7010 which is full of specific functions. Superfast service, excellent document. Thank you very much!

Customers who bought this product also purchased

HITACHI 12220T Service Manual	HITACHI 11225 Service Manual	HITACHI 192R Service Manual
HITACHI 13VR3B Owner's Manual	HITACHI 11225T Service Manual	HITACHI 32FX41B Service Manual

Click to see text excerpt from the manual

CP-X385WCP-X385W
Replacing the Lamp
1. Switch the projector OFF, remove the power cord from the power outlet,
and wait at least 45 minutes for the unit to cool.
2. Prepare a new lamp.
3. Check that the projector has cooled sufciently, and gently turn it upside
down.
4. Loosen the two screws as shown in the diagram, and remove the lamp
cover.
5. Loosen the three screws, and gently remove the lamp while holding the
grips. Touching the inside of the lamp case may result in uneven coloring.
6. Install the new lamp and tighten the three screws rmly.
Also steadily push the opposite side of the screwed lamp into the unit.
7. Replace the lamp cover in position and tighten the two screws rmly.
8. Gently turn the projector right-side up.
CAUTION
Ensure that screws are tightened properly. Screws not tightened
fully may result in injury or accidents.
Do not use the projector with the lamp cover removed.
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp. When the lamp has been replaced after the LAMP indicator is
red, or the CHANGE THE LAMP message is displayed, complete the following operation within ten minutes
of switching power ON. The power will be turned off automatically in over 10 minutes.
1. Switch power ON, and select the LAMP TIME on the OPTION menu.
2. Depress the RESET button for at least 3 seconds while lamp time is being displayed.
The reset menu will then appear.
3. Select RESET on the menu with the button, and wait until the timer display is cleared.
NOTE:
Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always when replacing the
lamp. The message functions will not operate properly if the lamp timer is not reset correctly.
2021