CP-X444(C11XMB)/CP-X440(C11XM25)
6-10 Related Messages
When the units power is on, messages such as those shown below may be displayed. When any such message
is displayed on the screen, please respond as described below.
Although these messages will be automatically disappeared around several minutes, it will be reappeared every
time the power is turned on.
MessageDescription
CHANGE THE LAMPThe time the lamp timer has counted is approaching 2000 hours.
Preparation of a new lamp, and an early lamp change is recommended. After you
AFTER REPLACING LAMP, have change the lamp, please be sure to reset the lamp timer .
RESET THE LAMP TIMER.
CHANGE THE LAMPThe time the lamp timer has counted is approaching 2000 hours, so a lamp
change within ** hours is recommended.
AFTER REPLACING LAMP, When lamp usage reaches 2000 hours, the power will automatically be turned off.
RESET THE LAMP TIMER.Please change the lamp by referring to the section Lamp.
After you have changed the lamp, please be sure to reset the lamp timer.
THE POWER WILL BE
TURNED OFF**hrs later.
CHANGE THE LAMPAs the time the lamp timer has counted has reached 2000 hours, the power
will soon be automatically turned off.
AFTER REPLACING LAMP, Please immediately turn the power off, and change the lamp by referring to the
section Lamp. After changing the lamp, please be sure to reset the lamp timer.
RESET THE LAMP TIMER.
THE POWER WILL BE
TURNED OFF 0 hrs later.
NO INPUT IS DETECTEDThere is no input signal.
ON ***Please con rm the signal input connection, and the status of the signal source.
The horizontal or vertical wavelength of the inputted signal is outside of the
SYNC IS OUT OF RANGEresponse parameters of this unit.
ON *** fH *****kHz fV *****Hz
Please con rm the specs for this unit or the signal source specs.
The internal portion temperature is rising.
Please turn the power OFF, and allow the unit to cool down at least 20 minutes.
After having con rmed the following items, please turn the power ON again.
Is there blockage of the air passage aperture?
CHECK THE AIR FLOW
Is the air lter dirty?
Does the peripheral temperature exceed 35C?
If the same indication is after the treatment, please set the HIGH at FAN SPEED
of the item SERVICE of the OPTION menu.
REMINDERA note of precaution when cleaning the air Ţ lter.
***HRS PASSED AFTER THEPlease immediately turn the power OFF, and clean or change the air filter by
LAST FILTER CHECK.
FILTER MAINTENANCE IS ESSENTIALreferring to the Air Filter section of this manual. After you have cleaned or
changed the air lter, please be sure to reset the lter timer.
TO REMOVE WARNING MESSAGE,
RESET FILTER TIMER.
SEE MANUAL FURTHER INFO.
NOTE A lamp has a nite product life. Lamps are characterized by the fact that, after long hours of
usage, a lamp will no longer light up, or the lamp will break or burst, etc. This projector is equipped with an
automatic shut-down function, such that the power will automatically be turned off when lamp usage time
has reached 2000 hours. Please be aware, however, that among lamp types, there are major differences in
product lifetimes; a lamp may thus fail to light even prior to the functioning of the automatic shut-down func-
tion of this projector.
27 |
ACEC
HITACHI
