E
N
Installation Guide
G
L
PreparationI
SBefore installation, check the radio operation with antenna and speakers.
H
Disconnect the cable from the negativ�) battere (y terminal (see caution below).
Unit should be installed in a horizontal position with the front end up at a con10venient angle, but not
more than 30!.
Caution:
For installation to cars with trip or navigational computers, all electronic memory settings
previously registered in the computer will be lost when the battery terminal is disconnected. For
this type of car, battery could not be disconnected. Therefore, extra care should be taken to
prevent short circuitting.
In-dash Installation
53 mm
Installation Opening
In-dash installation can be done if the carOs
dashboard has an opening for this unit as shown in
182 mm
Fig. 1. The carOs dashboard should have a
thickness of 4.5 mm - 6 mm in order to make the
Fig. 1
installation of the unit.
Installation Precautions
This equipment, if possible, should be installed by a professional installer.
In case of difficulty, please consult your nearest authorized Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system (car) with negative ground.
2. Follow the electrical connection on page 18 carefully. Failure to do so may result in damage to the
unit.
3. Connect the power lead after other connections are made.
4. Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT)
terminal.
5. Insulate all exposed wires to prevent short circuitting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment
before connecting it to this unit.
Supplied Hardwares
No.ItemDiagram QtyNo.ItemDiagram Qty
Mounting Collar1 Mounting Bolt (5 mm A)1
Hex. Nut (5 mm A)1 Power Connector1
Rear Support Strap1 Dismounting Plate1
Tapping ScrewRemovable Face
1 1
(5 mm A x 16 mm)Plate Case
13
CQ-RG131W |
ACEC
PANASONIC
