Installation (Continued)
P PreparationP Installation Hardware
Warning: If your vehicle is equipped with air bagNo.ItemDiagram QOty
and/or anti-theft systems, specific procedures may
be required for connection and disconnection of theq Mounting Collar*1
battery to install this product.
Before attempting installation of this electronic
w Plain washer (5mmż)2
component, contact your vehicle dealer or
manufacturer to determine the required procedure
and strictly follow their instructions. e Spring Washer (5mmż)2
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OFHex. Nut (5mmż)2
r
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
t Rear Support Strap1
AND PERSONAL INJURY.
Y Disconnect the cable from the negative batteryHex. Bolt
y1
terminal (see warning and caution below).(5mmż � 25 mm)
Y Remove Mounting Collar q from the main unitToothed Lock Washer
u1
temporarily, which are already mounted at shipment.*(5mmż)
Removal Tool
i2
(U-shaped)
Caution: Various settings that have been stored in
the memory in other on-board equipment (vehicle
o Antenna Connector1
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or to
back up the settings before disconnecting the
terminals.
(a) Using the rear support strap t
After completing installation of the main unit, set the
equipment again according to the record.
Y Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30u.
P Dashboard Installation
Installation Opening(b) Using the rubber cushion (option)
This unit can be installed in any dashboard having anRear support bracket
Rubber cushion (option) (provided on the vehicle)
opening as shown below. The dashboard should be
3/16� (4.75 mm) � 7/32� (5.56 mm) thick in order to be
able to support the unit.
Mounting bolt
(5 mmż)
q Mounting collar
26
CQ-5330U |
ACEC
PANASONIC
