Preparation
Set your cars ignition switch Press [SRC] (PWR: Power).
1ACCON2
to the ACC or ON position.
First Time Power On
\CQ-RX400U\ \CQ-RX200U\
Press [VOL] (PUSH SEL: Select) to
The demonstration message appears for initial 4
use. select DEMO.
Turn [VOL] counterclockwise.
Set your cars ignition switch to the ACC or
15For using the remote control, press [0] ( ).
ON position.
\CQ-RX400U\
\CQ-RX200U\
Notes:
Press [SRC] (PWR: Power).
2 To return to the regular mode, press [DISP].
Refer to the section on Function Settings.
Cancellation of DemonstrationHold down [VOL] (PUSH SEL: Select) for When NO USB (\CQ-RX400U\) or NO DISC is displayed,
3
2 sec. or more to open the function menu. the Demonstration cannot be cancelled.
Pull the insulation lm out from Note: Battery Information:
the backside of the remote control Battery Type: Panasonic lithium battery (CR2025) (Included
gently.in the remote control)
Battery Life: Approximately 6 months under normal use (at
room temperature)
Battery
Installation
The 12-hour system is used for the clock.Adjust the minute.
5
Press [DISP].
1
Minute entered
(clock display)
Hold down [DISP] for more than []: sets the minute ahead.
2
2 seconds. [ ]: sets the minute back.
Hour blinksPress [DISP].
6
Completed
Adjust the hour.
3
Notes:
Hour entered ADJUST is displayed before adjusting the clock.
Hold down [ ] or [] to change numbers rapidly.
[]: sets the hour ahead. When NO DISC is displayed, the clock cannot be
Clock Settingadjusted.
[ ]: sets the hour back.
Press [DISP].
4Clock Display at Power Off
Minute blinksPress [DISP] to change the display.
Display off
Clock display (Default)
- 13 - |
ACEC
PANASONIC
